Continental Fireplaces CX70NT User manual

EN
FR
PG
65
W415-1540 / 08.04.15
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
NEVER LEAVE CHILDREN OR OTHER AT RISK INDIVIDUALS ALONE WITH THE APPLIANCE.
INSTALLATION AND
OPERATING INSTRUCTIONS
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada /
103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone [phone] • Fax [phone] • www.continentalfireplaces.com • ask@continentalfire.on.ca
1.24C
$10.00
CERTIFIED FOR CANADA AND UNITED STATES USING ANSI/CSA METHODS.
SAFETY INFORMATION
!WARNING
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
- WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbour’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call the
fire department.
- Installation and service must be performed by a
qualified installer, service agency or the supplier.
If the information in these instructions
are not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
HOT GLASS WILL CAUSE
BURNS.
DO NOT TOUCH GLASS UNTIL
COOLED.
NEVER ALLOW CHILDREN TO
TOUCH GLASS.
!
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and shall be installed for the protection of children
and other at-risk individuals.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certified kit is used.
Decorative Product: Not for use as a heating appliance.
BARRIER
CX70 ILLUSTRATED
SAFETY BARRIER
CONFORMS TO AMERICAN NATIONAL STANDARDS: ANSI Z21.50-2012, CERTIFIED TO CANADIAN CSA 2.22-2012 FOR VENTED GAS FIREPLACES.
CX70PT & CX70PTE
PROPANE GAS MODEL
CX70NT & CX70NTE
NATURAL GAS MODEL

2
W415-1540 / 08.04.15
EN
NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
TABLE OF CONTENTS
1.0 INSTALLATION OVERVIEW 3
2.0 INTRODUCTION 4
2.1 CX70 DIMENSIONS 5
2.2 GENERAL INSTRUCTIONS 6
2.3 GENERAL INFORMATION 7
2.4 RATING PLATE INFORMATION 8
3.0 VENTING 9
3.1 VENTING LENGTHS AND COMPONENTS FOR DIRECT VENT INSTALLATIONS 10
3.2 TYPICAL VENT INSTALLATION 11
3.3 SPECIAL VENT INSTALLATIONS 12
3.3.1 PERISCOPE TERMINATION 12
3.4 MINIMUM AIR TERMINAL LOCATION CLEARANCES 13
3.5 VENTING APPLICATION FLOW CHART 14
3.6 DEFINITIONS 14
3.7 ELBOW VENT LENGTH VALUES 14
3.8 TOP EXIT HORIZONTAL TERMINATION 15
3.9 TOP EXIT VERTICAL TERMINATION 17
4.0 INSTALLATION 19
4.1 WALL AND CEILING PROTECTION 19
4.1.1 HORIZONTAL INSTALLATION 20
4.1.2 VERTICAL INSTALLATION 20
4.2 USING FLEXIBLE VENT COMPONENTS 21
4.2.1 HORIZONTAL AIR TERMINAL INSTALLATION 21
4.2.2 VERTICAL AIR TERMINAL INSTALLATION 22
4.2.3 APPLIANCE VENT CONNECTION 23
4.3 USING RIGID VENT COMPONENTS 23
4.3.1 HORIZONTAL AIR TERMINAL INSTALLATION 23
4.3.2 VERTICAL AIR TERMINAL INSTALLATION 24
4.3.3 RESTRICTING VERTICAL VENTS 24
4.4 MOBILE HOME INSTALLATION 25
4.5 GAS INSTALLATION 26
4.6 OPTIONAL WALL SWITCH (MILLIVOLT ONLY) 26
5.0 FRAMING 27
5.1 MINIMUM FRAMING DIMENSIONS 28
5.2 MINIMUM ENCLOSURE CLEARANCES 30
5.2.1 ALCOVE CLEARANCE TO COMBUSTIBLES ENCLOSURE 31
5.3 NON-COMBUSTIBLE FACING MATERIAL 32
5.4 MINIMUM COMBUSTIBLE MANTEL CLEARANCES 33
5.5 NAILING TAB INSTALLATION 33
6.0 FINISHING 34
6.3 SAFETY SCREEN / DOOR REMOVAL AND INSTALLATION 35
6.4 LOG PLACEMENT 36
6.5 GLOWING EMBERS 37
6.6 LOGO PLACEMENT 37
6.7 WIRING DIAGRAM (ELECTRONIC) 38
7.0 OPERATION 39
7.1 CX70NT/CX70NTE & CX70PT/CX70PTE (MILLIVOLT) 39
7.2 CX70NTE & CX70PTE (ELECTRONIC) 40
7.3 GENERAL TRANSMITTER LAYOUT (ELECTRONIC ONLY) 41
7.4 INITIALIZING THE TRANSMITTER/BATTERY HOLDER FOR THE FIRST TIME 41
7.5 TEMPERATURE DISPLAY 42
7.6 FLAME HEIGHT 42
7.7 BLOWER SPEED 42
7.8 NIGHT LIGHT DIMMER CONTROL 43
7.9 CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION 43
7.10 KEY LOCK 43
7.11 LOW BATTERY / MANUAL BYPASS 43
7.12 BATTERY HOLDER/BACKUP INSTALLATION (ELECTRONIC ONLY) 44
8.0 ADJUSTMENT 45
8.1 PILOT BURNER ADJUSTMENT 45
8.2 VENTURI ADJUSTMENT 45
9.0 MAINTENANCE 46
9.1 FLAME CHARACTERISTICS 46
9.2 ANNUAL MAINTENANCE 47
9.3 CARE OF GLASS 47
10.0 REPLACEMENTS 48
10.1 NIGHT LIGHT REPLACEMENT 48
10.2 DOOR GLASS REPLACEMENT 49
10.3 BLOWER REPLACEMENT 50
11.0 CX70 OVERVIEW 51
12.0 CX70NT/PT MILLIVOLT VALVE TRAIN ASSEMBLY 52
13.0 CX70NTE/PTE ELECTRONIC VALVE TRAIN ASSEMBLY 53
14.0 CX70 ACCESSORIES 54
15.0 TROUBLESHOOTING (ELECTRONIC) 55
16.0 TROUBLESHOOTING (MILLIVOLT) 58
NOTE: The camera icon indicates video tutorials are available as additional reference, visit
http://www.napoleonfireplaces.com/category/product-support/support-centre/

3
W415-1540 / 08.04.15
EN
1.0 INSTALLATION OVERVIEW
See the section
“MINIMUM MANTEL
CLEARANCES”
See the section
“NON-COMBUSTIBLE
FINISHING”.
See the section
“RATING PLATE
INFORMATION
Side
Wall
See the section “VENTING”
and “INSTALLATION”.
See the section
“FRAMING”
See the section
“FRAMING - MINIMUM
CLEARANCE TO
COMBUSTIBLE
ENCLOSURES” for
non-combustible
materials such as tile,
marble, granite, etc.
IMPORTANT: Extra
support may be
required.
See the section “MINIMUM
ENCLOSURE CLEARANCES”
for drywall (or other combustible
material).
SAFETY BARRIER
CX70 ILLUSTRATED
Batteries must be disposed of according to the local laws and regulations. Some batteries may be recycled,
and may be accepted for disposal at your local recycling center. Check with your municipality for recycling
instructions.

4
W415-1540 / 08.04.15
EN
2.0 INTRODUCTION
3.1D
!
WARNING
• THIS APPLIANCE IS HOT WHEN OPERATED AND CAN CAUSE SEVERE BURNS IF CONTACTED.
• ANY CHANGES TO THIS APPLIANCE OR IT’S CONTROLS CAN BE DANGEROUS AND IS PROHIBITED.
• Do not operate appliance before reading and understanding operating instructions. Failure to operate appliance according to
operating instructions could cause fire or injury.
• Risk of fire or asphyxiation do not operate appliance with fixed glass removed.
• Do not connect 110 volts to the control valve.
• Risk of burns. The appliance should be turned off and cooled before servicing.
• Do not install damaged, incomplete or substitute components.
• Risk of cuts and abrasions. Wear protective gloves and safety glasses during installation. Sheet metal edges may be sharp.
• Do not burn wood or other materials in this appliance.
• Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid burns
or clothing ignition.
• Young children should be carefully supervised when they are in the same room as the appliance.
Toddlers, young children and others may be susceptible to accidental contact burns. A physical barrier is
recommended if there are at risk individuals in the house. To restrict access to an appliance or stove, install an
adjustable safety gate to keep toddlers, young children and other at risk individuals out of the room and away from hot
surfaces.
• Clothing or other flammable material should not be placed on or near the appliance.
• Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.
• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
• Even after the appliance is out, the glass and/or screen will remain hot for an extended period of time.
• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These
screens and guards must be fastened to the floor.
• Any safety screen, guard or barrier removed for servicing the appliance, must be replaced prior to operating the
appliance.
• The appliance is a vented gas-fired appliance. Do not burn wood or other materials in the appliance.
• The appliance area must be kept clear and free from combustible materials, gasoline and other flammable vapors and liquids.
• Under no circumstances should this appliance be modified.
• This appliance must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.
• Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control which has been under water.
• Do not operate the appliance with the glass door removed, cracked or broken. Replacement of the glass should be done by a
licensed or qualified service person.
• Do not strike or slam shut the appliance glass door.
• When equipped with pressure relief doors, they must be kept closed while the appliance is operating to prevent exhaust fumes
containing carbon monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also
cause the surrounding combustible materials to overheat and catch fire.Only doors / optional fronts certified with the unit are to be
installed on the appliance.
• Only doors / optional fronts certified with the unit are to be installed on the appliance.
• Keep the packaging material out of reach of children and dispose of the material in a safe manner. As with all plastic bags, these
are not toys and should be kept away from children and infants.
• As with any combustion appliance, we recommend having your appliance regularly inspected and serviced as well as having a
Carbon Monoxide Detector installed in the same area to defend you and your family against Carbon Monoxide.
• Ensure clearances to combustibles are maintained when building a mantel or shelves above the appliance. Elevated temperatures
on the wall or in the air above the appliance can cause melting, discolouration or damage to decorations, a T.V. or other electronic
components.
• A barrier designed to reduce the risk of burns from the hot viewing glass is provided with this appliance and shall be
installed.
• If the barrier becomes damaged, the barrier shall be replaced with the manufacturer’s barrier for this appliance.
• Installation and repair should be done by a qualified service person. The appliance should be inspected before use and
at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from
carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air passageways of
the appliance be kept clean.
• This appliance uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel
Ltd.

5
W415-1540 / 08.04.15
EN
2.1 CX70 DIMENSIONS
33 1/8"
841mm
CX70 ILLUSTRATED
18 1/2"
470mm
7 3/16"
182mm
1 15/16"
50mm
GAS
INLET
5"
127mm
11 13/16"
299mm
8"
203mm
35"
890mm
11 5/16"
288mm
33 1/8"
841mm