Coolaroo BEACH CABANA User manual

BEACH CABANA
YELLOW STRIPE
1.8×1.8m
ASSEMBLY GUIDE AND
OPERATING INSTRUCTIONS
Gale Pacic Limited
145 Woodlands Drive, Braeside,
Victoria 3195 Australia
Coolaroo and Xceltex are registered
trademarks of Gale Pacic Limited
Made in China
For help with product assembly or for any other questions
you may have, contact our Customer Service Department.
Australia toll free: 1800 331 521
New Zealand toll free: 0800 555 171
Item Code: 505363
THANK YOU
FOR PURCHASING A
COOLAROO PRODUCT
Our beach cabana fabric is tested to meet UPF50+ and the highest UVE
eectiveness. Whilst beach cabanas oer sun protection and can help to
reduce UV exposure, they do not provide 100% protection. Scattered and
reected UV radiation from surfaces such as water can still damage skin and
cause sunburn. It is therefore recommended to always combine shade with
clothing, a broad-brimmed hat, sunglasses and sunscreen.
coolaroo.com
1
YEAR
PRODUCT WARRANTY
AND LIMITATION OF LIABILITY
Coolaroo products are manufacture by Gale Pacic Limited
ACN 082 263 778 (Gale). Gale provides the following
warranty in relation to Coolaroo products (“Product”).
The benets of this warranty are in addition to any rights
and remedies imposed by Australian Consumer Law, NZ
Consumer Guarantees Act 1993, and state and federal
legislation that cannot be excluded. Nothing in this warranty
is to be interpreted as excluding, restricting or modifying
any applicable legislation to the supply of goods and
services which cannot be excluded, restricted or modied.
WARRANTY
Gale warrants that, subject to the exclusions and limitations
below, all parts of the manufacture and assembly of the
Product will be free from defects in materials and workmanship
for a period of one (1) year for the frame and fabric from the
date of purchase.
If a defect appears in the Product before the end of the
warranty period and Gale nds the product to be defective
in materials or workmanship, Gale will, in its sole
discretion, either:
a) replace or repair the Product or the defective part of the
Product free of charge; or
b) refund the purchase price of the Product.
Gale reserves the right to replace defective parts of the
Product with parts and components of similar quality, grade
and composition where an identical part or component is
not available.
The warranty will not apply where:
a) the Product has been altered or modied by someone
other than Gale or its authorised agent;
b) the alleged defect in the Product is within acceptable
industry variances;
c) Gale cannot establish any fault in the Product;
d) the defect in the Product has arisen due to the
customer’s failure to install and use the Product in
accordance with the instructions provided;
e) the defect in the Product has arisen due to the
customer’s request to customise the Product;
f) the Product has been subject to abnormal conditions,
including environment, temperature, water, re,
humidity, pressure, stress or similar.
The warranty does not extend to:
a) damage or defects caused by normal wear and tear,
b) water or sun damage; or
c) any other damage caused by the customer placing other
equipment, furniture or material in close proximity to the
Product.
Gale makes no express warranties or representations other
than set out in this warranty.
The repair or replacement of the Product or part of the
Product is the absolute limit of Gale’s liability under this
express warranty.
WARRANTY CLAIMS
1) Upon purchasing the Product, the customer must
register their warranty by completing the Coolaroo
online warranty registration at www.coolaroo.com.
Alternatively, the customer can contact Coolaroo
Customer Service on 1800 331 521 (AU) or 0800 555 171
(NZ) for assistance.
2) If a fault covered by warranty occurs, the customer must
contact Gale using the contact details provided.
3) Any warranty claim must be accompanied by proof of
purchase and details of the alleged defect.
4) The customer must bear the cost of the transport of the
Product to and from Gale or the authorised agent to make
the warranty claim, and all insurance of the Product.
AUSTRALIAN CONSUMER LAW
Nothing in this agreement is intended to have the eect of
contracting out of any applicable provisions of the
Competition and Consumer Act 2010 or the Fair Trading
Acts in each of the States and Territories of Australia,
except to the extent permitted by those Acts where
applicable.
This warranty is not transferable, and applies only to the
initial purchaser of the installed Product.
In addition to the above warranty, Australian Consumer law
and other state and territory legislation may imply
warranties or conditions or impose liability on Gale in
relation to the Product or its supply which cannot, or can
only to a limited implied warranties or conditions and such
liability, and for the warranty described above:
a) all warranties and conditions (whether express or
implied, statutory or otherwise) relating to the Product
or its supply are expressly excluded; and
b) Gale will not be liable for any loss or damage suered by
any person (including the purchaser of the Product) in
any way relating to or arising from the Product or its use
(including loss or damage arising from the negligence of,
or contributed to by, Gale).
If liability for breach by Gale of a warranty or condition or any
other liability imposed on Gale by legislation which cannot be
excluded may be limited, Gale’s liability is limited to the
extent permitted by law, and if liability may be limited in any
one of a number of ways, Gale’s liability is limited in any one of
the permitted ways chosen by Gale in its absolute discretion.
The Purchaser acknowledges that the Purchaser does not
rely on the skill or judgment of Gale as to whether or not the
Products are t for any particular purpose.
The Purchaser indemnies Gale from every liability, loss,
damage, cost or expense directly or indirectly incurred or
suered by Gale caused by or contributed to by the
Purchaser’s failure to:
1) adequately provide or display safety markings or safety
information on or with the Products;
2) comply with any law about the Products or their use;
3) take any reasonable precaution to bring to the attention
of any potential users of the Products any dangers
associated with Products;
4) any negligence or breach of duty by the Purchaser or any
breach by the Purchaser of these terms.

ASSEMBLY GUIDE
STEP 1
• Find a at location in the sand to pitch the cabana shelter.
• Undo the rope from the storage bag and remove the beach cabana shelter.
• Remove the accessories and stakes bag from the storage bag.
STEP 2
• Screw the sand
anchor into the sand
until it reaches the
depth marker.
• If using the shelter
during strong winds,
ensure the post is
buried deeper until
the shelter can
stand rmly.
STEP 4
• Fill the four corner
pockets with sand to
secure the cabana.
• For earthy terrain,
insert the included
stakes into the
bottom of each
corner pocket.
• The cabana shelter
features eight
internal pockets
for storage.
STEP 3
• Connect the central
poles together.
• Open the cabana and
push upwards to
extend the arms
outward.
• Adjust the height of
the cabana to suit
your requirements.
1.8m
1.8m
The diagrams in this manual are for assembly and operation only.
Illustrations may dier from the umbrella’s actual appearance.
CARE AND MAINTENANCE
If the canopy is wet, allow to dry naturally in the open position before
storing. If necessary, clean the fabric with a hose.
Components subject to turning and sliding can be treated with a non-
staining lubricant spray (silicon-based).
WARNING
When assembling and using this product, safety precautions should always be followed to reduce
the risk of personal injury and damage to equipment.
Please read all instructions before assembly and use.
Install on level ground.
This is a non-permanent structure, do not use in extreme weather conditions including heavy rain
or high winds.
Do not leave the beach cabana open unattended.
Do not place the product near an open ame or too close to any heat source e.g. heaters and BBQs.