Coolaroo BRIGHTON User manual

CANTILEVER UMBRELLA
BRIGHTON
ASSEMBLY GUIDE AND
OPERATING INSTRUCTIONS

WARNING
When assembling and using this product, safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Please read all instructions before assembly and use.
Two or more people are recommended for safe assembly.
Keep all children and pets away from assembly area.
Install on level ground.
Check all nuts and bolts for tightness before use and regularly during use.
This is a non-permanent structure, do not use in extreme weather conditions including
heavy rain or high winds.
Do not leave the umbrella unattended when open.
Do not place the product near an open ame or too close to any heat source such as
heaters or BBQ’s.
The diagrams in this manual are for assembly and operation only.
Illustrations may dier from the umbrella’s actual appearance.
CARE AND MAINTENANCE
When not in use, close the umbrella, fasten canopy and store in a
dry place. If the canopy is wet, allow to dry naturally when
opened up before storing.
If necessary, clean the fabric with a hose.
DO NOT use umbrella over or near harsh chemicals or open ames
including but not limited to chlorine, grills, barbecues and re pits.
Components subject to turning and sliding can be treated with a
non-staining lubricant spray (silicon-based).

ASSEMBLY GUIDE
STEP 1
Take all of the parts out of box 1 and 2 to ensure they are all present before
starting construction.
Box 1
a) Umbrella frame and cover
b) Screws x4 (M8x30)
c) Washer x8
d) Allen key x 1
e) USB charger x 1
f) Crank handle x 1
g) Solar panel x 1
h) Light controller x 1
Box2
i) Fillable base
needle grooves
2.8m
3.5m
(M8X30)
(Ø16XØ8.2X2)
a.
b.
c.
d.
e.
f.
g.
h.
i.

STEP 2
Attach the solar panel (g) to the top of the umbrella. Inset the power cable to the
underneath of the panel. Attach the panel by rotating clockwise until it is tight.
Note: The solar panel requires 6 hours of sunlight to charge batteries.
STEP 3
Fill base (i) with water or sand. Once full and stable, use the Allen key (d) use screws
(b) and washers (c) to x the umbrella frame to the llable base (i). You will need
one person to stabilise the umbrella and hold it into position whilst the second
person attaches the frame to the base with screws and washers.
b. (M8X30)
①
a.
d.
d.
b.
c.
i.
①
②

STEP 4 – TO OPERATE
Undo the Velcroumbrella ties to free the canopy. Pull the trigger on the easy glide
handle and li until it locks into the lowest position. Open the umbrella by inserting
and winding the crank handle.
STEP 5
To open the canopy, wind the crank handle in a clockwise direction. To close the
canopy, wind the crank handle in an anti clockwise direction.
Close
Open
f.
f.