Coopers of Stortford 8161 User manual

A. FR NT PANELS F DRAWERS x2
B. SIDE PANELS F DRAWERS x4
C. B TT M PANELS F DRAWERS x2
D. BACK PANELS F DRAWERS x2
E. T P PANEL x1
F. SIDE PANELS x2
G. KICKB ARD x1
H. FR NT CR SSBAR x1
I. BACK CR SSBAR x1
J. BACK PANEL x1
1. SH RT SCREWS x18
2. L NG SCREWS x8
3. LABEL PLATE x2
4. HANDLES x2
5. SCREWS F R PLATES AND HANDLES x12
6. CAM L CKS (1 B LT AND 1 DRUM/SET) 18 SETS
7. W DEN PLUGS x12
8. METAL BARS x4
Parts and assembl
Attach 2 side panels (B) to front panels( A) using cam
lock (6).
Slide in Bottom Panel of Drawers (C) between the assembled section,
aligning it with the grooved sections.
Fix Back Panels of Drawers (D) to assembled section using Short Screws
(1) and Long Screws (2). Repeat steps 1-3 for both drawers.
WARNING
•Do NOT get wet. Wipe up
spillages immediately to
avoid stains and damage
to filing cabinet.
• It is recommended that
the filing cabinet is
located on a flat level
surface.
•Do NOT locate on a
downward slope due to
risk of injury as this will
cause the drawers to fall
open unaided and will
cause the filing cabinet
itself to over balance and
tip forwards.
• Take care when moving
the filing cabinet. It is
recommended to remove
all files from the drawers
before moving.
• Distribute weight load
evenly between drawers.
CLEANING
• Wipe clean with a soft
damp cloth.
• Polish using standard
household furniture polish.
DISPOSAL
• Dispose of all paper, cartons
and plastic in accordance with
your local recycling
regulations. At the end of the
product’s lifespan please
dispose of it at an authorised
household waste recycling
centre.
6
B
B
A
C
D
2
1Please turn over
1.
2.
3.
2 Drawer Filing Cabinet 8161/8162 Instructions
Please read carefull before use and retain for future reference.

Fix Label Plate (3) and Handle (4) to assembled drawers using
Screws for Plates & Handles (5). Align 2x metal bars (8) which
hold the suspension files, with recesses in back and front of
drawer and slot into place.
5. Attach Front Crossbar (H) and Back Crossbar (I) to
Side Panels (F) using Cam Locks (6) and Wooden Plugs
(7). Then in the same manner, fix the second Side Panel
(F) to the assembled section.
Attach kickboard (G) to side panels
using cam lock (6) and wooden
plugs (7) attach back panel (J ) to
assembled section using short
screws (1).
Fix Top Panel (E) to the assembled
section using Cam Locks (6) and
Wooden Plugs (7).
Pull out the runners and slide the silver
ball bearing runners forward. Align the
drawer with the extended runner and
slide the drawer into place. Repeat for
both drawers.
5
F
F
J
1
G
E
6
6
H
I7
7
6
3
4
4.
5.
6.
8.
7.
8