Corby CO9028 User manual

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 1 -
These instructions are for your safety. Please read through them
thoroughly before use and retain for future reference. Failure to
follow them could cause injury and/or property damage.
These instructions apply to the products shown below.
Styles may vary.
This appliance is not intended for use by persons including children with
reduced physical, sensory, mental capabilities, or lack of
experience/knowledge; unless supervision or instruction concerning the
use of this appliance has been given by the person(s) responsible for
their safety.
Use & Care Manual
Steam Iron

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 2 -
SPECIFICATIONS
FEATURES & CONTROLS
1. Soleplate
2. Skirt
3. Temp regulator
4. Body/water tank
5. Control lamp
6. Wire tube
7. Upper-cover
8. Spray button
9. Steam jet button
10. Steam knob
11. Water inlet
12. Spray nozzle
USAGE
Attention! Only iron garments with this appliance.
Ironing without steam
1. Place the iron its stand
2. Electrical connection - make sure that the voltage (see name plate)
and the mains voltage match.
3. Sort out the garments according to their ironing temperatures. Start
with the lower temperatures using the temperature regulator (3):
●Synthetics, silk (low temp)
●● Wool (med temp)
●●● Cotton, linen (high temp)
4. Insert the mains plug into a correctly installed earthed socket.
5. The control lamp (5) lights up. As soon as it shuts off, the set
temperature is reached (approx. 1-2mins). Now you can iron.
6. When the iron is not in use always unplug the appliance from the
mains.
Rated voltage
220-240V
Water volume
145ml
Rated frequency
50Hz
Weight
0.83KG
Rated power
1200W
Soleplate size
155 cm2
Temperature range
65-230°
Holding method
Standing
Extra strong steam
method
Pressing
Accessory
One cup
Standard steam
Dropping
Size
250 x 108 x
115mm
Function
Burst of steam, standard steam, vertical burst of
steam, spray dry of ironing .

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 3 -
Ironing with steam
1. Using the filling beaker (provided), fill the water tank (4) through the
water inlet (11) with pure water - up to degree of hardness 2.
Please use distilled water instead if the water is harder that
previously stated.
2. Turn the steam knob (10) to " ", in order to begin steam ironing.
“” --- max position
“”--- off position
Steam jet function
1. Turn off the steam knob (10) first.
2. Turn the temp regulator (3) to max position.
3. After the indicator goes off, press the steam jet button (9).
4. At most, it can release steam 7 times continuously (approx.
pressing the button once every second).
Spray function
In order to moisten an area, press the spray button (8).
Auto shut-off function
The iron will automatically shut off if left standing still.
In upright position it will auto shut-off after 8 mins.
In horizontal position it will auto shut-off after 30 secs.
Note: always allow the iron to cool down completely before
packing the appliance away.
CLEANING & STORAGE
Always unplug the iron before cleaning.
Clean the iron with a slightly damp cloth.
Do not use any abrasive cleaning agents.
To clean the iron and remove deposits of starch or water soluble,
rub the soleplate (1) with a soft cloth soaked in vinegar and water.

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 4 -
GENERAL SAFETY
1. Read these instructions carefully before putting the appliance into
operation and keep them somewhere safe.
2. The appliance is designed exclusively for private use and for the
envisaged purpose. This appliance is not intended for heavy
commercial use. Do not use it outdoors. Keep it away from
sources of heat, direct sunlight, humidity (never submerge it in any
liquid) and sharp edges. Do not use this appliance with wet hands.
If the appliance is wet or in unsuitable conditions unplug it.
3. When cleaning or putting it away, switch off the appliance and
always pull out the plug from the socket. Do not use this product
without full knowledge/experience of how it functions. If you should
leave the area where the appliance is being used, always turn the
product off.
4. Make sure that children cannot gain access to the appliance
especially during use.
5. Check the appliance and the cable for damage regularly. Do not
use the appliance if it is damaged.
6. Do not attempt to make repairs to the device. Always contact a
qualified technician.
7. Pay extra attention to the SPECIAL SAFETY instructions.
SPECIAL SAFETY
1. WARNING! The ironing base becomes hot very quickly and takes
a long time to cool down. Please do not touch it.
2. Some smoke may be emitted at first use, this is not a fault.
3. When the iron is not in use it should be placed in its stand. Ensure
that the surface on which the stand is placed is stable.
4. Always unplug the iron when filling it with water. Never fill it with
more than 1 beaker full.
5. Let the iron cool completely before packing it away.
6. The iron must not be left unattended while it is switched on.
7. Do not use this appliance if it has been dropped or has any signs
of damage.

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 5 -
CONNECTION TO THE MAINS SUPPLY
(for UK plug type only)
1. Check that the voltage marked on the product corresponds with
your supply voltage.
2. This product is fitted with a 13A plug complying with BS1363. If
this plug is unsuitable or needs to be replaced, please note the
following:
Important: The wires in the
mains lead are coloured in
accordance with the following
code:
GREEN/YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
WARNING - THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings identifying the
terminals in your plug proceed as follows.
The green and yellow wire must be connected to the terminal in the
plug which is marked with the letter E or with the earth symbol
or coloured green and yellow.
The blue wire must be connected to the terminal marked N or
coloured black.
The brown wire must be connected to the terminal marked L or
coloured red.
Important - any cut off plug should be disposed of safely to
prevent hazard. There is a danger of electric shock if a cut off plug
is inserted into a socket outlet.

Customer telephone helpline: 08448 809301
Helpline email: [e-mail]
www.CorbyofWindsor.com
CO9028 V1_040510
- 6 -
CONFORMITY WITH DIRECTIVES
Conforms with relevant European Directives.
ENVIRONMENTAL PROTECTION
(WEEE)Waste Electrical and Electronic Equipment
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
This appliance complies with the RoHS directive which restricts the use
of certain hazardous substances in electrical and electronic equipment.
This Directive bans the placing on the EU market of new electrical and
electronic equipment containing more than agreed levels of lead,
cadmium, mercury, hexavalent chromium, polybrominated biphenyl
(PBB) and polybrominated diphenyl ether (PBDE) flame retardants.