Core Products LD214 User manual

Height:643mm
Width:800mm
Depth:300 mm
60min
4 drawer wide chest
REF. LD214
BATCH NUMBER
BEFORE YOU START ASSEMBLY
Please check that you have all the correct
parts and fittings as detailed on the
assembly instructions.
We recommend that you build your
furniture on top of a soft clean cover to
ensure the unit does not get marked or
damaged during assembly.
FOR DAMAGED/REPLACEMENT PARTS Please
visit
www.coreproducts.co.uk/parts
PLEASE RETAIN THIS LEAFLET ALONG WITH YOUR DELIVERY
NOTE / RECEIPT FOR FUTURE REFERENCE.
Core Products 05/2021
Page 1
KAIFU7151
Thank you for choosing this furniture.
BEFORE YOU START ASSEMBLY please store the carton at room temperature for 48 hours or more co the contents can
acclimatise.
PLEASE RETAIN ALL PACKING UNTIL YOU HAVE COMPLETED ASSEMBLY.
Information about your furniture.
This furniture has been manufactured from surface coated wood based manufactured boards.
Caring for your furniture.
Extreme temperature can cause slight movements in the board material so please avoid placing your furniture close to radiators
or other sources of heat.
Please avoid exposing your furniture to continued bright sunlight as this can affect the colour,
any fluid spills should be removed as quickly as possible
Always lift your furniture when moving as dragging may cause damage to your furniture or flooring.
Use mats or coasters to help protect against heat.
Do not stand on your furniture .
Aftercare.
Wipe all surfaces with a dry cloth and the occasional use of a normal household furniture Polish, do not use detergents or
chemicals on your furniture.
After assembly remove any visible component identification stickers, these should remove easily however any remaining adhesive
residue can be removed with a label adhesive removal liquid available from most DIY or hardware stores.
For models with drawers we also recommend you use a household spray polish or curtain track spray on the drawer runner
tracks. Please do not use any wax based products, chemicals or detergents on this furniture.
Regularly check all fixings to ensure they are tight.

     
／ 卿多 了/
40mm 15mm 8*40
mm 3.5*14 mm
   
 /
“
怎'®i 1勹0
3.5*18
mm 3.5*35
mm
ASSEMBLY HARDWARE
ASSEMBLY PARTS MAX SUGGESTED LOADS
15kg
5kg
5kg
5kg
5kg
Page 2
X4
X4
X4
X4
X4
X4

A
40mm :
8*40 mm

，
3.5*14 mm

己2
J
｀


，
8*40 mm 3.5*14 mm 250mm
田、C
I
Page 3
Top

飞 霉
B
15mm
*4
3.5*35 mm
 
✓ 1-�
Turn minifix cams to
the right to tighten.
Page 4


／
40mm

/
3.5*35 mm
叨
辜
15 mm

乡
8*40 mm
 
/
，
3.5*18 mm
x4
｀
x4 x4
250mm 3.5*14 mm
x4 x4
Page 5

k
Page 6
Angle the drawer slightly to ensure
that the wheel at the back of the
drawer slide goes behind the front
wheel on the cabinet slide. Then lift the
drawer up and slide it into the
channel of the drawer slide.
1
After you finish assembling
the cabinet, take off the
adhesive numbers on the
parts' edge.
Wall
Wall