6 of 12 | English English | 7 of 12
• Use the attached cords
to secure the product
to bed. If used on an
adjustable bed, ensure
that the blanket or
cord cannot becoming
trapped or stretched.
• Keep away from re or
ammable materials.
• Do not insert pins or sharp
objects into the blanket.
(Fig.2)
• Do not tuck under the
mattress.
• Do not use when wet or
around liquids including
bathtubs and showers.
• Do not use the appliance
when folded or creased.
(Fig.3)
• Unplug electrical power
cord when not in use.
• Do not use power cord or
control with wet hands to
prevent electric shock.
• Only operate with the
supplied lead and
controller.
• Product intended only for
household use.
• If the supply cord is
damaged, it must
be replaced by the
manufacturer.
• This appliance is intended
for indoor household use
and similar applications.
Do not use outdoors.
• Children younger than
3 must not use the
appliance due to their
inability to react to
overheating (Fig.1)
• Do not use a hot water
bottle at the same time
as using the blanket
• When storing the blanket,
allow it to cool down fully
before folding.
• Always refer to your
electric blanket’s wash
label before washing.
Gentle cycle at a
maximum of 30°C -
FOR MODELS S1 and
D1 ONLY.
Read instruction
manual
Do not dry clean
Do not tumble dry
Do not insert pins
Do not iron
Do not use folded
Do not bleach
Not to be used by children
ages 3 or younger
SYMBOLS EXPLAINED
—
FITTING INSTRUCTIONS
—
Always ensure the blanket is covered
during use to retain heat.
1. Unfold the blanket and lay it on the
bed above your mattress.
2. Align the blanket so that the socket
for the lead and controller are by the
pillow.
3. Use the support ties to secure the
product to the mattress.
4. Once the blanket is secure, connect
the controller to the mattress by
plugging it into the socket.
5. Place your bottom sheet OVER the
electric blanket.
(Blanket must always be covered in
order to retain heat).
USING YOUR ELECTRIC BLANKET
—
Once the blanket has been securely fitted
to the bed, plug the power lead into the
closest socket at the pillow end. Use an
extension lead where necessary to ensure
the power cord is not stretched and
cannot be tripped over.
This product is designed to pre-heat your
bed to the desired temperature using
the temperature control settings on the
supplied controller.
Controller
1. The number on the controller
represents the following heat
settings:
0 = OFF
1 = LOW HEAT
2 = MEDIUM HEAT
3 = HIGH HEAT
Move the heat setting on the
controller to the desired heat setting
in order to pre-heat your bed.
2. The blanket will start to heat after a
few minutes providing it is covered
with a duvet or blanket.
3. Allow 15-20 minutes for the
blanket to begin warming up and
approximately 60-90 minutes for
the blanket to reach maximum
temperature. This time will vary
depending on the temperature of the
room, the type of bedding used, and
the thickness of the covering blanket
or duvet.
NOTE: If using the blanket all night, use
only low level setting 1. This will provide
a safe and comfortable temperature for
all-night use.
3
2
1
0
0
Gentle cycle at a
maximum of 40°C -
FOR MODEL K1 ONLY
4
