Quick Start Guide - ver.2
BLUESTAR 2010
Thank you for purchasing the BLUESTAR 2010 from COSTAR Technologies. You will soon be
using your existing cell phone to communicate hands free using your existing vehicle
electronics.
Installation is easy. Simply follow the steps below, and feel free to contact us at
Step 1: Locate the onstar module in your vehicle. It can be located beneath the rear seat,
behind the glove box, or in the trunk depending on your vehicle. Refer to the COSTAR
Technologies Forum for vehicle specific information.
Step 2: Unplug the onstar module’s white connectors, J1 and J2. In cases where the GMLAN
signal is located on the black J4 connector, it is necessary to wire this signal into the white J1
connector so that the BLUESTAR module can communicate with the radio. Refer to External
GMLAN Connection Application Note.
Step 3: Plug the white connectors into the BLUESTAR 2010.
Step 4: Pair your phone. The passkey / access code for the BLUESTAR is 0000.
Step 5: Adjust volume if necessary. The BLUESTAR module volume can be adjusted by
pressing the RED button to enter ‘Volume Adjust’ mode. You can then use the White and
BLUE buttons to adjust the default volume. You will hear beep tones while doing this. Press
the Red key to save this setting.
Step 6: Press the white key to initiate voice dialing. More detailed information on advanced
features can be found on the website www.costartech.com.
Enjoy the BLUESTAR and feel free to share your experience on our forum particularly if you
have any installation tips or ideas on how to make this product even better.
COSTAR Technologies fully stands behind their product with a complete 60 day satisfaction
guarantee. If you are not 100% satisfied with the BLUESTAR please let us know and we’ll do
everything we can to get you up and running as soon as possible, or your money back.
