Costway baby joy BB5591 User manual

Baby Cribs
BB5591

Please read all instructions carefully and keep it for future reference.
General Warnings:
Attention: To prevent possible injury by entanglement, remove this toy when the child starts
trying to get up on its hands and knees in a crawling position.
Danger! Keep all small parts and packaging materials for this product away from babies and
children, otherwise they may pose a choking hazard.
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all Packaging, separate and count all parts and hardware before Installation.
Please ensure that all parts are correctly installed, incorrect Installation can lead to a Danger.
We recommend that, where possible, all items are assembled near to the area in which
they will be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during construction, and place the product always on a flat, steady
and stable surface.
2

1.Open the bag and take all the
parts out.
2.Unfasten the 3 velcro straps that
are around the mattress.
3.Place the playpen in the vertical
position and open the touch
fasteners to remove the mattress.
4.Grasp the playpen at the
short sides and unfold the playpen.
3
TO UNFOLD

5.Draw upward the four side rails separately, starting with the short
When completely lock in position you will hear a click sound.
6. Make sure that all 4 sides of the playpen are correctly locked in
position then push down the base pressing the centre.
WARNING! Don’t reverse the above steps. It won’t be possible
to make the 4 rails locked in position if the centre of the base
is down.
4

7. Place the mattress in the playpen with the padded side up. Insert
the four velcro tabs through the slots in the base of the playpen.
5

The Usage Of Second Layer
3.Then place the mattress inside the bassinet .
1.Install the Bassinet in the inside of the playpen with all the zippers
and then stick on velcro.
NOTE! Ensure zipper is completely attached all the way around
before each use.
2.support tubes into the sleeve provided on the bottom of bassinet
and connect them together.
VELCRO
VELCRO
6

changing table
a. Unfold the changing table and tidy the surface. Open the velcro at
both ends and press the spring key to join the steel tubes.
b. Please make sure that the buckle is installed when the baby is lying
on the changing table.
2. Find the 4 plastic clips, and attach to the
underside of the changing table; Turn the
changing table over and attach to the end
playpen top rail.
NOTE. Always make sure the plastic clips
under change table are securely fastened
to changing table and playpen .
3. put the changing table to the top rails and make it correctly locked
in position.
ab
7

Storage
Toy Bar
4. Attach the plastic clips to either side of the playpen as shown.
8
1.Put the two plastic hooks into
the corresponding holes.

TO FOLD
1. Remove all the accessories,take the mattress outof the bassinet. Pull the
band in the centre of the base upwards.Then push downward the side rails,
do the same for four sides.
2. Draw together all four corners of the playpen. Then insert the secondlayer
inside the playpenand place the other accessories.Fasten the velcro straps
that are around the mattress, and then place inside the travel bag.
WARNING! If the top rails do not release, ensure that the base
is raised fully and lift the rails slightly before pressing the
release button.
9

CAUTION
WARNING
READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY JEOPARDIZE THE SAFETY OF YOUR CHILD.
YOUR CHILD'S SAFETY IS YOUR RESPONSIBILITY. CAUTION!
NEVER LEAVE THE CHILD UNAT TENDED: IT MAY BE DANGEROUS.
PAY UTMOST CARE WHEN USING THE PRODUCT.
heat radiation such as electric or gas radiators etc. placed in the
vicinity of bed.
• Never use the bed in case any of its parts is broken, torn or lacks;
use only components approved by the bed's manufacturer.
• Never leave inside the bed or close to it, things that may help the
child to get out of the bed or causing the risk of strangulation,
such as curtain or window blind cord etc.
• Do not use the cot without the base.
1. Long-term exposure to direct sunlight may cause fading of fabrics.
In such cases, any complaints will not be accepted.
2. The Company reserves itself the right to modify the bed structure
without the obligation to inform the customers about it.
3. Customers will be charged for any repairs necessary because of
careless use.
Never leave your child unattended!
10