Costway HW66085 User manual

Contact Us !
Do NOT return this item.
Folding Bed with Mattress
HW66085
USER’S MANUAL
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Please give us a chance to make it right and do better !
Contact our friendly customer service department for help first.
Replacements for missing or damaged parts will be shipped ASAP !
US office: Fontana UK office: Ipswich AU office: Truganina
US:[e-mail]
UK:[e-mail]
AU:[email protected]

0302
Before You Start
Read each step carefully before starting. It is very important to
ensure each step followed in correct order, otherwise assembly
difficulties may occur.
Most of board parts are labeled or stamped on the raw edges. Have
a check to make sure all parts are included.
Work in a spacious area, preferably on a carpet close to where the
unit will be used.
Keep the handtools close at hand. Do not use power tools to
assemble your furniture. They may scratch or damage the parts.
Hardware inside
EN
A B
C C1
D E
F F1
x 2PC x 2PCS
x 4PCS x 4PCS
x 1PC x 4PCS
x 2PCS x 2PCS

0504
EN
1 2
(2) Extended center legs

0706
EN
3 4
Cross bar must be positioned
between caster and leg flat side facing up

0908
EN
5 6

Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary.
Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Liquid spills should be removed immediately. Using a soft clean cloth, blot the
spill gently. Avoid rubbing.
Check bolts/screws periodically and tighten them if necessary.
It is best to keep your furniture in a climate-controlled environment. Extreme
temperature and humidity changes can cause fading, warping, shrinking and
splitting of wood.
It is advised to keep furniture away from direct sunlight as sun may damage
the finish.
Proper care and cleaning at home will extend the life of your purchase.
Following these important and helpful tips will enhance your furniture as it
ages.
Further advice about wood
furniture care
1110
EN
A) Carefully remove all packaging.
B) Unfold bed and remove hardware pack.
1) Close bed and secure with clip lock bar (item A) Fig 1 see
illustration.
2) Place folded bed on its side and extend the two center legs. Fig 2.
3) Place flat side of leg cross bar (item B) across the center legs
aligning holes of cross bar with underside legs Fig 3, insert caster
(item C) up through cross bar and THEN leg. Secure with nut and
tighten with spanner (item D) repeat for remaining 3 casters.
4) Release snap click lock bar, carefully unfold one side of the bed until
the leg retention bar hole aligns with the corresponding extended
outer leg hole Fig 4. Secure with nut and bolt (item F) and spanner
(item D). repeat for opposite side.
This process enables the automatic leg action.
Please note bed must be partially unfolded for the holes to
align.
5) Stand bed upright and attach the 4 plastic caps by inserting them
into the pre drilled holes in each outer leg (item E) Fig 5.
6) Handles must be held firmly when operating to prevent bed from
opening too rapidly.
To operate bed, hold both handles firmly, release clip lock bar
(item A).
Gently lower one side to the floor repeat for opposite side.
To close simply fold and secure with clip lock bar.
Please do not place hands near hinges when operating the bed.
Recomended maximum weight 120 kgs 264lbs