4
www.costway.com www.costway.com
5
1.
2.Design is fine, simple, and beautiful, with combined structure,
easy to operate and clean.
3.High speed electric motor with overheating protection is adopted,
high efficiency, time saving, energy saving, high service life of
the motor.
4.Safety lock unit for switching is specially designed, in order to
make sure safety and reliability in use.
5. Design with anti-drip function juice mouth.
For the juicer with large diameter, entire apple or pear can be put
in for juicing, no cutting apart needed, easy and quick.
Performances
Attention before using
1.This machine is set with safety unit, whenthe handle does not
fasten the cover or the cutter seat is not fastened, the motor
cannot turn, so as to ensure safety for the user.
2. When disassembling or assembling the juicer, press the upper
of feed port of the cover with your hand, then force the handle
to slide in or out of cover slot.
3.When disassembling juicing net, first remove the cover and
residue barrel, then turn the middle ring up to 30 degrees by
holding juicing nozzle with your hand, and take up, the juicing
net will automatically leave the rotor.
4. In order to avoid damage, before using, first check power
supply for compliance with rated voltage.
5. Clean all parts able to disassemble (refer to the section of
"maintenance and cleaning").
6. When assembling, please carefully read the diagram of "name
and position of main components".
7. Please carefully read the "attentions" before using.
1. Before using, please confirm the button switch of the main
machine in stop state, in this way, in case assembly is not
completed, starting the main machine can be avoided, so
unnecessary damagefor persons or property avoided.
2. Before juicing, first confirm juicing net and rotor clutched in
position, and no hard contact between juicing net cutter and
transparent cover. Put the transparent cover on, put the handle
into the cover slot, then turn on the machine.
3. Before using, please make sure to put the juice mouth to drip
position, and after turning off the machine, put the juice mouth
to anti-drip position to avoid juice come out without juice cup
and make the table dirty.
4. For using, assemble according to the diagram of "name and
position of main components". Turn on power supply, press
switch to let the machine run no-load for 5 sec. Put prepared
vegetable or fruit into feed port of the juicer, press with the
pushing bar, evenly, hard and slowly, juice of the vegetable or
fruit can be found, original, fresh, goodfor health.
5. Note: when pressing food with the pushing bar, force shall be
even or indirect, pressing force shall not be more than 1 kg, no
too sudden force, otherwise, juicing effect will be reduced.
Operating time
This machine is designed with button switches of O grading, I
grading, II grading (O for stop, I for weak grading,II for strong
grading). For juicing, select strong grading,for operating time,
after operating for 1min, stop for 1min, then use again. After the
above operation is performed for three times, stop for 15 min, do
not operate until the motor is cooled, in this way, service life of
Juicing
