CPC DRUMQUIK PRO User guide

DRUMQUIK®PRO
Dispensing System for
Professional Chemical Management
SYSTEM INSTALLATION GUIDE
Chemical Dispensing Made Easy
Simple steps to install and use the DrumQuik
®
PRO
Shipping Plug
Drum Insert
Dip-tube
Coupler
Locking Ring
WHY USE A DRUMQUIK
®
PRO?
Safety: Minimize spills, fumes and environmental impact
Performance: High flow capacity
Easy: Intuitive locking ring design for
quick connection
Durability: Built to withstand harsh
operating conditions
FDA Materials: Suitable for transfer
of food products
Vapor Management: Ported vent
allows control of fumes, blanket gas
connection or pressure dispensing
Economic: Low cost for high
volume, single-trip containers
Recyclable Materials: Allow easy disposal with containers
Liquid Port
Vent
Check
Valve
Vent Port
Copyright © 2015 by Colder Products Company. All rights reserved. CPC, Colder Products Company, Colder Products and
Colder are registered trademarks with the US Patent & Trademark Office.
INSTALL5002 01/10 BP/5M
Printed in the U.S.A.
COLDER PRODUCTS COMPANY
1001 WESTGATE DRIVE
ST. PAUL, MINNESOTA 55114
U.S.A.
PHONE: [phone]
FAX: [phone]
TOLL FREE: 800-444-2474
[e-mail]
cpcworldwide.com
COLDER PRODUCTS COMPANY GMBH
OSTRING 19
D-63762 GROSSOSTHEIM
GERMANY
PHONE: [phone]
FAX: [phone]
[e-mail]
cpcworldwide.com
COLDER PRODUCTS COMPANY LIMITED
FLAT B, 29/F, WEST GATE TOWER,
7 WING HONG STREET, CHEUNG SHA WAN
KOWLOON, HONG KONG
PHONE: [phone]
FAX: [phone]
asiapacifi[e-mail]
cpcworldwide.com

Installation
The DrumQuik®PRO drum insert
assembly replaces one of the
drum’s bung plugs and is torqued
and shipped as part of the drum
package.
1. Fully press dip-tube into drum insert socket. 2. Place the drum insert assembly in drum.
Dispensing
Remove the shipping plug from
the drum insert assembly, then
connect the DrumQuik PRO
coupler, locking it into place.
Vapor Management
Three vapor management options:
1. Fully open to vent vapors to the
atmosphere.
2. Connect CPC check valve (e.g. 2879800)
to allow make-up air in, without allowing
fumes to escape.
3. Connect a CPC quick disconnect coupling
for blanket gas (N2, CO2) or for pressure
dispensing.
3. Torque insert with drum wrench or 1/2" drive
torque wrench and a CPC torque socket tool
(CPC PN 2408900).
Note: Contact CPC for torque recommendations.
1. Turn shipping plug counterclockwise to remove.
(Use a large flat blade, #4 Phillips screwdriver
or coin.)
2. Insert coupler into drum insert assembly. 3. Turn the coupler locking ring clockwise until stop
is reached (approximately 2 full turns); valve is
opened during this process.
1. Vent port fully open. 2. Vent port outfitted with CPC check valve. 3. Vent port shown with CPC quick disconnect
coupling.