Dispense-Rite SLR-LID-2 Series User manual

DISPENSE-RITE ®SLR-LID-2 SERIES
INSTALLATION & OPERATION INSTRUCTIONS
The lid dispenser is shipped completely assembled but it will require in-counter installation prior to initial usage.
Important note: This product is not intended for use with all lid types and compatibility is not guaranteed with all lids.
Prior to fabricating any holes in your counter please verify that your specic lids are compatible with this product.
Lids that are tightly nested or have deep extrusions may not be easily removed and should not be used with this product.
The recommended installation for this lid dispenser will provide lid dispensing in an upward direction. For certain lid types
and special mounting applications a downward dispensing may be preferred. For this option please be sure the mounting
head has been installed with the “UP” arrow pointed to the bottom instead of the top.
SECTION ONE - LID DISPENSER INSTALLATION
1
2
3
4
Diversied Metal Products, Inc.
2205 Carlson Drive • Northbrook, IL 60062 • [phone] • fax [phone]
www.dispense-rite.com • [email protected]
5-1/4"
134 mm
Cut a 5-1/4” diameter hole into the mounting surface.
Insert the lid dispenser into the mounting hole. Push lid
dispenser all the way in until it is ush with the counter.
Align the “UP” mark to the top for an upward lid
dispensing application (recommended).
Align the “UP” mark to the bottom for a downward
lid dispensing application (optional).
Drill four 9/64” pilot holes in the locations shown below.
Fasten the dispenser with the four #10 screws provided.
Place lid dispenser cover ring on the mounting head
and rotate clockwise to secure.
Discharge opening should be facing the top for
upward lid dispensing applications (recommended).
Discharge opening should be facing the bottom for
downward lid dispensing applications (optional).

SECTION TWO - LOADING AND OPERATION
1
2
3
4
Diversied Metal Products, Inc.
2205 Carlson Drive • Northbrook, IL 60062 • [phone] • fax [phone]
www.dispense-rite.com • [email protected]
To load the dispenser the cover ring must be removed.
Turn the ring bezel counter clockwise to remove from
dispenser.
Load a full sleeve of lids with the bottom side of the
lids facing outward.
Important note: do not load lids in the wrong direction
or they will not discharge properly.
While holding lids in place with your hand replace cover
ring and turn clockwise to reattach to the dispenser.
To remove lids grasp the rim and pull straight out of
opening.
ALTERNATIVE FACEPLATE
Depending on the specic lid dispenser model ordered the
unit may have been supplied with an alternative lid
dispensing faceplate. The alternative faceplate is for use
with lids that are difcult to remove from the standard
faceplate. To utilize the alternative faceplate simply remove
the ring bezel, replace the faceplate insert and re-install the
ring bezel onto the dispenser as shown below.
LID DISPENSING PERFORMANCE TIPS
1. Always load lids with the bottom side of the lid facing
outward so that you may grasp the lid to remove.
2. This lid dispenser is intended primarily for use with at
beverage lids only. Lids that are tightly nested or deeply
extruded may not be compatible with this product.
3. Never overll the dispenser as it may increase the
difculty of removing lids.