______________________CPSQuickStepGuide
Pulse Clicker Ho
-To
2. Press the “+/-“key. The screen should now display Channel on the
middle line. The current channel is displayed in the top left. If this is the
number of the receiver you want the pad to work with, then press the enter
button and proceed to 4.
3. Enter the channel number you wish the pad to operate on and press the
enter button.
4. Now the screen should display Address, and the number in the top left will
by default match the sticker on the front end of the pad. This is the Pad
ID that the pad will respond as. If it is already set to the number you
want, proceed to 6.
5. Enter the number you wish the pad to respond as.
6. Press the enter button again, and then one more time when the pad
displays the next screen (an overview screen). This will save the settings
and power down the Pulse clicker.
