Press and hold the〔〕key on the top of the unit.
Press〔〕key and〔〕key simultaneously until the letter CH is blinking, press
〔〕key to select the number of Channel.
Press〔〕key and the screen will display CTC off , press〔〕key to select your
desired CTCSS/DCS ( CTCSS 1 –53, DCS 1 –104 )
Press〔〕key until “SC***” is blinking, to select the scanning ON/OFF by
pressing〔〕key and confirm it by pressing〔〕key. to cancel the scanning by
pressing〔〕key.
Press〔〕key until “Po***” is blinking, to select Power HI/Lo by pressing〔〕
key and confirmit by pressing〔〕Key.
Press〔〕key to complete this setting or to press〔〕key again to have the other
functions , press〔〕key to select number, you may press〔〕key at any time
to complete this setting.
Press〔〕key at the side and〔〕key simultaneously to LOCK /UNLOCK the unit,
after Lock, the unit can only be allowed to adjust volume or transmit and receive.
5.1 【Power On / Off】
To turn the radio on or off, press and hold the power on〔〕key .
5.2 【Volume】
Adjust the volume level by using〔〕key (8 steps)
5.3 【Transmission】
Press and hold the〔〕key while speaking at about 5cm from the microphone for
transmission. Release the〔〕key to return to standby mode.
5.4 【Reception】
Listen for activity on the selected channel.
5.5 【Key Lock】
Press〔〕key and〔〕key simultaneously to select Key Lock ON / OFF
5.6 【Channel Selection】
Press〔〕key and〔〕until “** CH” is blinking, to select the channel number by pressing
〔〕key and confirm It by pressing〔〕key . To select channel quickly, press and
hold the 〔〕key.
5.7 【CTCSS / DCS】
During setting, to press the〔〕key until “CTCSS / DCS***” is blinking, to select the CTCSS /DCS
number by pressing〔〕key and confirm it by pressing〔〕key.
4. CHANNEL SETTING BRIEF NOTE
