
6
ASSEMBLY & USE
ALWAYS use fresh cool water when operating the humidifier. ALWAYS make sure
detachable cord is attached to base. ALWAYS ensure the water level sensor float is
secure in the base.
1. WATER LEVEL SENSOR FLOAT (Page 4, Fig1)- Remove float from
plastic bag and place into the base as shown in
figure 1. IMPORTANT: water level sensor float must
be placed securely in the base (see
Troubleshooting).
2. WATER TANK (Page 4, Fig 2)- Place water tank
onto the humidifier base ensuring the Crane
Logo lines up with the Power Button for proper
water tank placement. Fill water into the Water
Fill Opening on the top of the water tank.
As shown in figure 2.
Figure 1. Figure 2.
ALWAYS HOLD WATER TANK WITH TWO HANDS WHEN FULL.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any medication, essential oils, vapor pads or salt into the tank.
3. MIST CHANNEL COVER (page 4, Fig. 2 #9)-Secure the mist channel cover onto the
water tank. You will hear an audible click on top and bottom of the mist channel
cover to secure placement.
4. WATER TANK DISK (page 4, Fig. 3 #12)-Place the Water Tank Disk, with disk lip down,
securely onto water tank opening.
5. MIST NOZZLE (page 4, Fig. 3 #13) -Place the mist nozzle securely onto the water tank
disk. Direct the mist output by turning the mist nozzle to the direction you want the
mist to emit.
Note: Do not attempt to move the humidifier while full Water Tank is placed on the
Humidifier Base. Doing so may cause leakage of water and/or Humidifier Base to
overfill.
6. CONNECT AC ADAPTOR CORD into the Plug Port (page 4, Fig. 3 #14). Plug the power
cord into a wall socket and turn on the unit by using the Power Button. PRESS POWER
BUTTON (page 4, Fig. 1 #5) 1x for low, 2x for medium, 3x for high and 4x to power off.
Note: The Power Indicator Light will illuminate in green indicating that the unit is on.
IMPORTANT: After 10 seconds, the indicator light will turn off but product will continue to
run. This feature allows the humidifier to be on without a visible illuminating light.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the mist output so the mist rises up to be
absorbed by the room air. If mist drops quickly, use the lower output setting so the mist is
rising up.
7. When the humidifier runs out of water, the Power Indicator Light will turn red and the
mist output will stop. This is a safety feature to prevent the humidifier from possibly
overheating and damaging the Nebulizer. Turn the humidifier off and unplug the
unit before removing and refilling the water tank. When emptying the humidifier
base, be sure to pour away from the fan outlet.