Crate&Barrel Spotlight Large User manual

HARDWARE
TOOLS REQUIRED
COMPONENTS
Made in Vietnam - r03 Page 1 of 2
Thank you for purchasing the Spotlight Large Desk.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
SPOTLIGHT LARGE DESK
Missing hardware? Please call 800.606.6387 for replacements.
4 - long
bolts
12- spring
washers
12 - flat
washers
2 - barrel
nuts
2 - screw
posts
2 - set screws
8 - short
bolts
Customer Service 800.967.6696 |Lastest instructions available at www.crateandbarrel.com
1 - tabletop
assembly
1 - crossbar
2 - leg frames
(1 left, 1 right) 1 Lay both leg frames face down on a clean, padded
surface as shown. Insert 1 screw post into each leg and
secure with a flat head screwdriver. Note: Make sure to
align slot on top of screw post parallel to leg. Do not over
tighten screw posts.
NOTE:
Make sure to align
slot of screw post
parallel to leg
NOTE:
Do not over
tighten screw
posts
left leg frame
right leg frame
phillips head screwdriver flat head screwdriver
(We recommend the use of hand tools instead of power tools)

Made in Vietnam - r03 Page 2 of 2
4 A) With the assistance of another adult, carefully place tabletop
assembly upside down on a padded surface. Fit dowels of legs into
corresponding holes in tabletop.
B) Fully extend drawers. Secure both leg frames from the inside with 8
short bolts, 8 spring washers and 8 flat washers. Insert 4 long bolts, 4
spring washers and 4 flat washers through the tabletop apron as shown.
Fully tighten, but do not over tighten all bolts with a phillips head screw-
driver. With the assistance of another adult, place desk assembly upright.
Assembly is now complete.
SPOTLIGHT LARGE DESK
2 A) With the assistance of another adult, position legs
as shown. Insert 2 barrel nuts into the crossbar as
shown. Use a flat head screwdriver to align the hole on
the side of the barrel nut with the hole on the end of the
crossbar.
B) Fit dowels of crossbar and screw posts of leg frames
into corresponding holes as shown. Make sure hole in
screw post aligns with hole in the top of the crossbar.
3 Secure crossbar to leg frames by inserting a set
screw into each barrel nut. Tighten with a phillips
head screwdriver, making sure set screw securely
engages the screw post of the leg frame.
CLEANING AND CARE
Clean surfaces with a dry or damp
soft cloth. Do not use abrasive
cleaners. Do not use furniture wax
or polish as the wood is finished
with a protective clear lacquer. It is
recommended to use coasters
(without rubber feet) to protect
surface from heat and water.
A
B
long bolt
short bolts
A
B
Align this hole with hole
on end of crossbar
NOTE:
Do not over tighten the bolts
Align this hole in
screw post
with hole in
top of crossbar
CORRECTLY ASSEMBLED
SIDE VIEW DETAIL
Customer Service 800.967.6696 |Latest instructions available at www.crateandbarrel.com