Crate&Barrel Spotlight User manual

HARDWARE
TOOLS REQUIRED
COMPONENTS
Made in Vietnam - r03 Page 1 of 2
Thank you for purchasing the Spotlight Desk. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or
padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
SPOTLIGHT DESK
Missing hardware? Please call 800.606.6387 for replacements.
4 - long
bolts
12- split
washers
12 - flat
washers
2 - barrel
nuts
2 - screw
posts
2 - set screws
8 - short
bolts
Customer Service 800.967.6696 |www.crateandbarrel.com
1 - tabletop
assembly
1 - crossbar
2 - leg frames
(1 left, 1 right) 1 Lay both leg frames face down on a padded surface as
shown. Insert 1 screw post into each leg and secure with a
flat head screwdriver. Important: Make sure to align slot on
top of screw post parallel to leg. Do not over tighten screw
posts.
IMPORTANT:
Make sure to align
slot of screw post
parallel to leg
phillips head screwdriver flat head screwdriver
(We recommend the use of hand tools instead of power tools)

Made in Vietnam - r03 Page 2 of 2
4 A) Place tabletop assembly upside down on a padded surface. Fit dowels of
legs into corresponding holes in tabletop.
B. Fully extend drawer. Secure both leg frames from the inside with 8 short
bolts, 8 split washers and 8 flat washers. Insert 4 long bolts, 4 split washers
and 4 flat washers through the tabletop apron as shown. Fully tighten, but do
not over tighten all bolts with a phillips head screwdriver.
With the assistance of another adult, place desk assembly upright.
Assembly is now complete.
SPOTLIGHT DESK
2 A) With the assistance of another adult, position
legs as shown. Insert 2 barrel nuts into the crossbar
as shown. Use a flat head screwdriver to align the
hole on the side of the barrel nut with the hole on the
end of the crossbar.
B) Fit dowels of crossbar and screw posts of leg
frames into corresponding holes as shown. Make
sure hole in screw post aligns with hole in the top of
the crossbar.
3 Secure crossbar to leg frames by inserting a set
screw into each barrel nut. Tighten with a phillips
head screwdriver, making sure set screw securely
engages the screw post of the leg frame.
CLEANING AND CARE
Clean surfaces with a dry or
damp soft cloth. Do not use
abrasive cleaners. Do not use
furniture wax or polish as the
wood is finished with a
protective clear lacquer.
A
B
Long Bolt
Short Bolts
A
B
Align this hole with hole
on end of crossbar
NOTE:
Do not over tighten the bolts
Align this hole in
screw post
with hole in
top of crossbar
CORRECTLY ASSEMBLED
SIDE VIEW DETAIL
Customer Service 800.967.6696 |www.crateandbarrel.com