Crave Curve Mini User manual

USER GUIDE

2
03
Package Contents
06 09
Connectivity Specifications
Overview
04 07
Audio Control
10
Troubleshooting
Powering Phone Calls
05 08 12
Safety
TABLE OF CONTENTS

3
Crave Curve Mini Speaker
Micro USB
Charging Cable
User Guide
PACKAGE C NTENTS

4
VERVIEW
Press and hold to turn the speaker on or o.
Press and hold the +or - buon
to increase or decrease volume.
Tap (without holding) the +or -
buon to switch between audio tracks.
Charge the Crave Curve Mini speaker with the provided
USB cable and your USB charger (not included) before
rst me use.

5
Press and hold the +or - buon
to increase or decrease volume.
Tap (without holding) the +or -
buon to switch between audio tracks.
Charge the Crave Curve Mini speaker with the provided
USB cable and your USB charger (not included) before
rst me use.
Power the speaker on/o by holding the power buon.
P WERING

6
Connecon via the 3.5mm stereo cable
(non Bluetooth opon)
- Connect your device to the 3.5mm port using a stereo
audio cable.
- Play audio from any device ulizing the 3.5mm output port.
CONNECT VITY
Connecon via Bluetooth
- Hold for several seconds to Power On.
- Listen for Power On tone, followed by Bluetooth
pairing signal.
- Enable Bluetooth funcon on your device.
- Speaker will remain in pairing mode unl
located on the device list.
- Select “CRAVE Curve Mini” speaker from the device list.
Once paired, you will hear Bluetooth connected tone.

7
Connecon via the 3.5mm stereo cable
(non Bluetooth opon)
- Connect your device to the 3.5mm port using a stereo
audio cable.
- Play audio from any device ulizing the 3.5mm output port.
Connecon via Bluetooth
- Hold for several seconds to Power On.
- Listen for Power On tone, followed by Bluetooth
pairing signal.
- Enable Bluetooth funcon on your device.
- Speaker will remain in pairing mode unl
located on the device list.
- Select “CRAVE Curve Mini” speaker from the device list.
Once paired, you will hear Bluetooth connected tone.
For best sound quality:
Place the speaker base
on a hard surface.
Face the speaker in
direcon of user.
Keep the device
within speaker range.
AUDIO CONTR L
01
02
03

8
PHONE ALLS
Using built-in speakerphone and microphone
Accept/end a phone call from
your phone directly.
USB Charge voltage:
DC 5V, 0.5A
Power Output:
5W

9
Accept/end a phone call from
your phone directly.
SPECIFICATIONS
Baery size:
500 mAh
Bluetooth range:
USB Charge voltage:
DC 5V, 0.5A
Power Output:
5W
Frequency:
90Hz – 20kHz
Size:
3.07x2.36x2.31 in
66 .

10
Speaker is disconnecng from phone/tablet
1 | Move your device closer to the speaker.
2 | Power cycle the speaker o/on and reconnect.
3 | Remove any visible obstrucon between the speaker and
your device.
4 | Check for signal interference from other devices in
proximity to the speaker.
Sound Quality
1 | Check if your phone/tablet/device is in close proximity
to the speaker.
2 | Remove any visible obstrucons between the speaker and
your device.
3 | Reduce volume on the device.
TROUBLESH TING

11
Speaker is disconnecng from phone/tablet
1 | Move your device closer to the speaker.
2 | Power cycle the speaker o/on and reconnect.
3 | Remove any visible obstrucon between the speaker and
your device.
4 | Check for signal interference from other devices in
proximity to the speaker.
Sound Quality
1 | Check if your phone/tablet/device is in close proximity
to the speaker.
2 | Remove any visible obstrucons between the speaker and
your device.
3 | Reduce volume on the device.
Unable to pair the speaker with your phone/tablet
1 | Check if Bluetooth funcon is enabled on your device.
2 | Check the speaker for low baery (plug into power source).
3 | Check if the speaker is possibly paired to another device.
4 | One Bluetooth enabled device should be available for
pairing at any given me, mulple enabled devices can cause
the speaker to pair to another device without you knowing.
Volume too low/volume too high
1 | Turn volume up or down on the speaker or your device.
2 | Check if the 3.5mm cable is well connected
(non Bluetooth opon).
TROUBLESH TING

12
Fire Safety
1 | Do not aempt to repair or take the speaker apart.
2 | Do not leave the speaker in direct sunlight and/or extreme
temperatures.
3 | Do not charge the speaker in wet or damp areas.
4 | Do not leave the speaker near an open re or hot surfaces.
Read safety precauons carefully to ensure your personal
safety and to prevent property damage
Drop/Fall
1 | Do not leave unaended on any surface, vibraon of the
speaker may cause movement.
S FETY
A

13
Electrical Safety
1 | Do not expose or use the speaker in rain, moisture, humidity
or near water.
2 | Do not disassemble, break open, crush, bend, puncture,
shred, microwave, paint or insert foreign objects into the
speaker.
3 | Clean using a dry cloth only.
Disposal
1 | Never dispose of the speaker through burning.
2 | Dispose of the speaker in accordance with local baery
disposal regulaons.
Read safety precauons carefully to ensure your personal
safety and to prevent property damage
S FETY
A

14
FCC INFORMATION
FCC Radiaon Exposure Statement FCC ID: 2AN7XCM5W01
This equipment complies with FCC RF radiaon exposure limits
set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules, operaon
is subject to the following two condions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operaon.
Warning: Changes or modicaons to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.

15
This equipment complies with FCC RF radiaon exposure limits
set forth for an uncontrolled environment.
FCC INFORMATION
( connued on the following page )
These limits are designed to provide reasonable protecon
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instrucons, may cause harmful interference to radio
communicaons.
However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which
can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interferenceby one or
more of the following measures:

16
FCC INFORMATION
Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.

18
@crave.direct @cravedirect
cravedirect.com
Quesons or comments? Please contact us at [email protected]om
Designed by Crave in USA.
Made in China.