CRC PRO BIKE BAG User manual

CHAIN REACTION CYCLES PRO BIKE BAG INSTRUCTIONS
1
Remove the pedals from your bike and
place them into pocket A as shown.
2
Turn your bike upside down (be careful
not to damage your saddle or scratch
your controls or bars).
3
Remove the wheels and set them aside
for now.
Select an appropriate CPI and t these in place of your hubs using QR levers or bolt through
axles as required to x them in place as you would a normal wheel/hub.
4B 5
Fit your rear wheel into the pocket in the
back wall of the bag.
4A
6A 6B
Undo the straps on the front and rear shock blocks so they are ready to accept the bike. Turn your bike up the right way
and position the CPI’s on top of the
appropriate shock block.
7A

11 12
Remove your handlebars, wrap them in
bubble wrap or similar (not included).
10
13 15
You are now ready to go travelling with
your bike!
14
Strap your handlebars to the Top Tube
of your frame.
7B 9
Strap your frame to the back of the
bag/wheel pocket. You may also need
to adjust the height of your seat so it
ts into the bag. (Be sure to leave the
saddle high enough so it lls all the
excess space if possible. This will
prevent anything from moving around).
8
Adjust the position of the blocks if
needed and secure the CPI’s in place
using the straps.
Place your front wheel into the pocket
on the opening ap of the bag.
Rotate stem 180˚.
Zip the bag closed.
Adjust the position of the middle shock
block so it is directly under the bottom
bracket. (This will prevent damage to
your chainrings). Remove padding from
block if needed.