Cree Lr4e series User manual

15˚ Shield Angle

LR4E-15

LR4E-15C

30˚ Shield Angle

LR4E-30

LR4E-30C

INSTALLATION INSTRUCTIONS

LR4E Light Engine

Including: LR4E-15, LR4E-15C, LR4E-30, LR4E-30C

• LR4-Engines (all versions) are designed for both Insulated

(completely buried in insulation) and Non-insulated appli-

cations.

• Designed for use with a 120 volt, 60 hertz protected circuit

(fuse box, circuit breakers) and 90° C rated supply wire.

• LR4E is for use with a H4 recessed pan assembly and must

be used within an enclosed recessed can. See installation

instructions for H4 for more information.

IMPORTANT SAFETY INFORMATION

Read all instructions before installation

1. WARNING - Risk of Electric Shock. Disconnect power at fuse or circuit

breaker before installing or servicing.

2. Check to make sure that all recessed can connections have been prop-

erly made and the xture is grounded to avoid potential electrical shocks.

3. Do not handle energized xture with wet hands, when standing on wet or

damp surfaces, or in water.

STEP 1:

Remove taped GU-24 socket from side wall

of recessed can and pull down to attach to

the top of the LR4E. Align pins and socket

and turn clockwise until locked. See

Figure 1.

STEP 2:

Remove the LR4E from the packaging and

rotate the “Flip Clips” clockwise until the

pointed tip of the clip lines up with the

arrow on the metal base. Loosen one of

the screws inside the H4 can. Unwind the

green ground wire and hook it over the

screw. Re-tighten screw to secure ground

hook. See Figure 2.

STEP 3:

Push the LR4E with the ﬂip clips in the

ready position up into recessed can until

the bottom ﬂange of the LR4E is ﬂush

with the ceiling. The LR4E should be ﬁrmly

gripping the can. To remove the LR4E

rotate counter-clockwise until clips release

and you can pull the unit down. See

Figure 3.

INSTALLING THE LR4E

123

Flip Clip

LIMITED CONSUMER PRODUCT WARRANTY FOR CREE® LR SERIES DOWNLIGHTS (including LE6™, LR4™ and LR6 Series)

Limited Warranty: Cree warrants to the original purchaser (the “Buyer”) of the Cree® LR Series downlight purchased (the “Product”), that the Product will be free from material defects in workmanship and materials under normal use and service

and conform to Cree’s written specications. This limited warranty may be transferred to subsequent purchasers of the Product, provided that such Product is resold in new condition and in its original packaging. This limited warranty extends for

a period of ten (10) years from the date of original purchase of the Product (the “Warranty Period”). There is NO WARRANTY in cases of damage to the Product in transit or damage caused by your negligence; abuse; abnormal usage; misuse;

accidents; damage due to environmental, corrosive or natural elements; improper power supply; failure to follow Cree’s instructions or applicable electrical codes; improper installation, storage or maintenance; damage due to acts of God; re;

vandalism; civil disturbances; power surges; alteration; mishandling; and incorrectly or improperly performing maintenance or repair by someone other than Cree or its authorized service provider. Remedy: If the Product proves defective during the

Warranty Period and the Product return procedures set forth below are followed, Cree will in its sole discretion, as its sole and exclusive obligation under this warranty, refund you the purchase price of the Product, repair the Product or replace the

Product without charge, F.O.B. Cree’s designated facility. Proof of original purchase date (e.g., sales receipt or original invoice) is required for this limited warranty to apply. CREE SHALL NOT BE LIABLE TO BUYER, OR TO ANYONE CLAIMING

UNDER BUYER, FOR ANY OTHER OBLIGATIONS OR LIABILITIES, INCLUDING, BUT NOT LIMITED TO, OBLIGATIONS OR LIABILITIES ARISING OUT OF BREACH OF CONTRACT OR WARRANTY, NEGLIGENCE OR OTHER TORT OR

ANY THEORY OF STRICT LIABILITY, WITH RESPECT TO THE PRODUCTS OR CREE’S ACTS OR OMISSIONS OR OTHERWISE. This limited warranty does not cover the cost of eld labor or expenses related to the repair or replacement of the

Product. Cree reserves the right to utilize new, reconditioned, refurbished, repaired or remanufactured products or parts in the warranty repair or replacement process. Such products and parts will be comparable in function and performance to an

original product or part, as determined by Cree in its sole discretion, and warranted for the remainder of the original warranty period. This limited warranty applies only to a Product purchased within the United States (including the lower 48 states,

the District of Columbia, Hawaii, Alaska, Puerto Rico and the U.S. Virgin Islands, but excluding APO/FPO addresses that are outside of those named jurisdictions) (collectively, the “Territory”). Replacement and repaired Product or parts will only be

shipped to addresses within the Territory, and refunds will only be credited to accounts located within the Territory. Making a Warranty Claim: Notice of any warranty claim should be sent to Cree at the following address: 9201 Washington Avenue,

Racine, WI 53406 or you may call Cree at (800) 236-6800 to receive a RGA# and instructions for return of the Product, freight prepaid. Further Limitations: TO THE EXTENT PERMITTED BY LAW, THE LIMITED WARRANTY AND REMEDIES SET

FORTH ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES AND REMEDIES (INCLUDING WITHOUT LIMITATION, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE).

IF WE CANNOT LAWFULLY DISCLAIM STATUTORY OR IMPLIED WARRANTIES, THEN TO THE EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES WILL BE LIMITED IN DURATION TO THE DURATION OF THIS EXPRESS LIMITED

WARRANTY AND TO REFUND, REPAIR OR REPLACEMENT SERVICE AS DETERMINED BY CREE IN ITS SOLE DISCRETION. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not

apply to you. IN NO EVENT SHALL CREE BE LIABLE FOR INCIDENTAL, COMPENSATORY, CONSEQUENTIAL, INDIRECT, SPECIAL OR OTHER DAMAGES. CREE’S AGGREGATE LIABILITY WITH RESPECT TO A DEFECTIVE PRODUCT

SHALL BE LIMITED TO THE MONIES PAID TO CREE FOR THAT DEFECTIVE PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.

This limited warranty gives Buyer specic legal rights, and Buyer may also have other rights which vary from state to state. Effective Date: January 1, 2013 LPN000006 Rev. I

LT4-15A

REMOVAL OF INSTALLED LR4E

NOTE: Make sure power to ﬁxture is

disconnected before attempting to

remove LR4E module from ﬁxture.

STEP 1:

Remove the reﬂector trim by rotating

trim counter-clockwise and gently

pulling down until the reﬂector trim

disengages from the lens.

STEP 2:

Rotate LR4E counter-clockwise until