Multi-Surface Mount Kit for TSS-752 Crestron TSS-752-MSMK
6•Multi-Surface Mount Kit for TSS-752: TSS-752-MSMK Installation Guide – DOC. 7603B
Installation
This section provides an installation procedure for each mounting scenario. “Glass
Mounting” starts below, “Drywall, Paneling, Concrete or Brick Mounting” starts on
page 9 and “Raceway Mounting” is on page 12. Be sure to review each procedure
before starting.
Glass Mounting
The touch screen can be mounted onto a flat pane of glass or similar smooth surface
(such as granite, marble, plaster, smooth stone or masonry) using the included glass
mounting plate. The back of the plate has an adhesive tape that permanently attaches
to the glass. After installation is complete, the raceway kit may be installed on a
smooth surface by following the “Raceway Mounting” procedure on page 12.
NOTE: Ensure the glass mounting surface is cleaned with a glass cleaning product
that does not leave a film and is free of debris before mounting. Once glass mounting
plate has been attached, it cannot be easily removed.
Complete the following procedure to attach the glass mounting plate. The only tools
and supplies required and not supplied are a level, tape, flathead screwdriver, #2
Phillips screwdriver, 1/4” hex driver, and a glass cleaning product that does not leave
a film.
1. Thoroughly clean and dry the glass mounting surface using a glass cleaning
product that does not leave a film.
2. Using the level, carefully tape a horizontal reference line that coincides with
the lower edge of the mounting bracket.
CAUTION: Adhesive on glass mounting plate is a high strength bond.
Once adhesive meets a surface, it cannot be easily removed or adjusted.
3. Remove the adhesive backing from the glass mounting plate.
4. Holding the glass mounting plate (4519682 or 4519718) at a 45 degree
angle to the glass, carefully align the lower edge of the mounting plate with
the level taped line. Do not allow adhesive backing to come in contact with
the glass.
5. Once aligned with the level reference line, carefully tilt the glass mounting
plate back until it is secured to the glass. Firmly press glass mounting plate
to the glass to ensure proper adhesion and that any trapped air bubbles are
removed.
6. Using a flathead screwdriver, carefully break away one of the C-shaped
knockouts on the top, bottom or sides of the plastic racer mount (4520154
or 4520155). For example, if the LAN cable is to enter the plastic racer
mount from the bottom, break away the C-shaped knockout on the bottom
of the plastic racer mount.
7. Run the network wiring through the hole created by removing the knockout
in step #6.
8. Attach the plastic racer mount to the glass mounting plate using the 1/4”
hex driver and the four included #04-40 hex nuts (2004878). Refer to the
following illustration.
