CTA ADD-PARAFS User manual

CTA Digital Floor Stand Component
For Kitting
ADD-PARAFS / ADD-PARAFSW / ADD-PARAFSS
INSTRUCTION - MANUAL
888-733-4448
CONTENTS:
Align the holes of the floor stand body
to the base plates. Make sure the
orientation of the base plate and body
is as shown in the example. Screw in
tightly with provided tool.
x4
x4
x4
x1
x1 x1
x1
x1
x4
INSTRUCTIONS:
1. Mounting Base to Floor Stand Body

888-733-4448
2. Setting up Cable Routing
Use the provided weighted pendant to route a cable through the stand. Start at the top through the
center of the VESA as shown and drop it down through the body and out the bottom as shown. In
the event that the cable end is too large, remove the screws of the VESA mount as shown and
remove the adaptor. Then drop the weighted pendant with cable after.
Have the cable at the top
hanging out of the VESA
mount and ready to be
plugged into whatever
device and VESA
compatible item that
mounts to the floor stand.
Locking Point
3. Adjusting VESA adaptor
Using provided tool, rotate clock wise to lock
VESA adaptor in place. Rotating counterclock-
wise will provide flexibility in rotations for
whatever VESA compatible item is installed.
4. Installing VESA compatible item example
Align mounting holes of your VESA compatible
item with the floor stand VESA adaptor. Screw
in from the front with the provided hhardware
and make sure to route cable into your device
**Enclosure is not included and for example
purposes