CTA PAD-VPOS2BC User manual

x8
x4
x8 x1
x1
x1 x1
x1
x2
Adjustable Table Mount
PAD-VPOS2BC
INSTRUCTION - MANUAL
with Universal Security Holder & Universal Security Enclosure
Instructions:
Contents:
1a. Setting up drill mount
Screw in base plate from below
with hardware as shown to the left
1b. Setting up kiosk
Drill in nails to the table as shown
Install (4) screws with base plate
from below as shown
888-733-4448

2. Installing Enclosure
Screw in (4) screws from the front through the enclosure
and VESA while holding the hex nuts from behind until
secured and tightened (Shown Above)
888-733-4448
Using the provided tool screw in (4) screws from the
front around the security holder
and hold the hex nuts from behind with fingers until
secured and tightened (Shown Above)
3. Inserting Tablet into Security Holder
1. Press and hold on the release button
to unlock the frame. Expand holder to fit your
tablet from corner to corner.
2. Install the tablet into the holder 3. Adjust the holder to fit your tablet
and retract to securely fit around the
corners of your tablet.
4. Inserting Tablet into Enclosure
1.Unlock the tablet enclosure by
rotating the key until it pop opens 2. Find the appropriate size foam
padding (included) for the tablet you
wish to use. Make sure device is
compatible for the enclosure
3. Lay your device in and connect any
cables or cords you have
4. If needed, make sure to lay-in the
correct masking cover. Then close
and lock the enclosure and you’re
ready to go.
**TABLETS NOT INCLUDED
**TABLETS NOT INCLUDED