CTA ADD-PARAFSV User manual

Premium Floor Stand Kiosk
with Graphic Slots & VESA Plate for Kitting (Black)
ADD-PARAFSV
INSTRUCTION - MANUAL
888-733-4448
CONTENTS: 1. INSTALLING BASE:
2. SETTING UP GRAPHIC CARD SLOT
J
F
1A. ALIGN BASE PLATE (A) WITH THE BODY (J) AND
ROTATE IN SCREW (F) FROM THE BOTTOM USING
THE PROVIDED ALLEN KEY TOOL (C).
2A. SLIDE OUT THE (2) GRAPHIC CARD PANELS IN THE FRONT AND BACK OF THE BODY (J). IF THERE IS A STICKER FILM, REMOVE
THAT FIRST. IF YOU HAVE PRINTED OUT A STICKER GRAPHIC, PLACE IT ONTO THE PANEL. IF YOU ARE USING A COMPLETE NEW
PANEL, YOU CAN REPLACE THE INITIAL PANELS THAT CAME WITH THE FLOOR STAND. PLACE ONE PANEL BACK FIRST, THEN THE
OTHER.
A

3. SETTING UP CABLE ROUTING
5. ATTACH VESA PLATE
5A. FIRST, WITH ALL THE ITEMS
ALIGNED, ROUTE ANY WIRES
THROUGH THE PLATE’S
OPENINGS.
5B. THEN ROTATE IN
SCREWS(G) AND WASHERS(E)
FROM THE TOP USING
PROVIDED TOOL (C) AS
ILLUSTRATED.
888-733-4448
4. ALIGN VESA PLATE
AND FRONT PLATE
COMPONENT AND WITH
FLOOR STAND
3A. WITH ONLY (1) PANEL BACK IN, SLIDE IN THE POWER CORDS AND ANY OTHER CORDS THAT
WOULD NEED TO BE CONNECTED TO THE TABLET THROUGH THE BODY AS SHOWN. THERE WILL BE
GAPS AT THE TOP AND BOTTOM FOR THEM TO ROUTE OUT TO THE POWER SOURCE AND TO THE
DEVICE. SLIDE IN SECOND PANEL WHEN ROUTING IS FINISHED.
G
E
C
B
D
J
4A. ALIGN THE VESA PLATE BASE (B) WITH THE
FRONT PLATE BASE (D) TO THE TOP OF THE
FLOOR STAND (J). MAKE SURE ALL THE HOLES
ARE ALIGNED AND READY FOR INSTALLATION.