CTA PAD-PARAF1 User manual

Customizable Premium Locking Floor Stand Kiosk
with Graphic Card Slot for Branding
PAD-PARAF1/ PAD-PARAF1W
INSTRUCTION - MANUAL
888-733-4448
CONTENTS: 1. INSTALLING BASE:
ALIGN BASE PLATE WITH THE BODY AND
SCREW IN FROM THE BOTTOM USING THE PROVIDED
ALLEN KEY TOOL AND RELATED HARDWARE NEEDED.
2. SETTING UP GRAPHIC CARD SLOT
SLIDE OUT THE (2) GRAPHIC CARD PANELS IN THE FRONT AND BACK. IF THERE IS A STICKER FILM, REMOVE THAT FIRST. IF
YOU HAVE PRINTED OUT A STICKER GRAPHIC, PLACE IT ONTO THE PANEL. IF YOU ARE USING A COMPLETE NEW PANEL, YOU
CAN REPLACE THE INITIAL PANELS THAT CAME WITH THE FLOOR STAND. PLACE ONE PANEL BACK FIRST.

3. SETTING UP CABLE ROUTING
WITH ONLY (1) PANEL BACK IN, SLIDE IN THE POWER CORDS AND ANY OTHER CORDS THAT WOULD
NEED TO BE CONNECTED TO THE TABLET THROUGH THE BODY AS SHOWN. THERE WILL BE GAPS AT
THE TOP AND BOTTOM FOR THEM TO ROUTE OUT TO THE POWER SOURCE AND TO THE DEVICE.
SLIDE IN SECOND PANEL WHEN ROUTING IS FINISHED.
4. ATTACH VESA PLATE
ATTACH VESA PLATE AT TOP. ROUTE ANY WIRES
THROUGH THE PLATE’S OPENINGS AND PLACE IN
SCREWS FROM THE TOP IN THE SCREW HOLES
AS SHOWN.
888-733-4448
5. ATTACHING THE TABLET ENCLOSURE
UNLOCK AND OPEN TABLET ENCLOSURE,
ATTACH SCREWS AND HEX BOLTS AS SHOWN
THROUGH THE BACK OF THE ENCLOSURE
TO COMPLETE SETUP.
6. SETTING UP
ENCLOSURE & TABLET
6A - UNLOCK THE TABLET ENCLOSURE BY
ROTATING THE KEY UNTIL IT POPS OPEN
6B - FIND THE APPROPRIATE SIZE INCLUDED
FOAM PADDING FOR THE TABLET YOU WISH
TO USE. MAKE SURE DEVICE IS COMPATIBLE
FORTHE ENCLOSURE
6C - LAY YOUR DEVICE IN AND CONNECT ANY
CABLES OR CORDS YOU HAVE
6D - IF NEEDED, MAKE SURE TO LAY-IN THE
CORRECT MASKING COVER. THEN CLOSE AND
LOCK THE ENCLOSURE AND YOU’RE READY TO
GO.