CTA PAD-UGT User manual

2. Attaching Foam Pad to Tablet Holder
Gooseneck Chair Clamp
PAD-UGT / PAD-UGTW
INSTRUCTION - MANUAL
CONTENTS:
INSTALLATION:
888-733-4448
1A. Align main body (A) with the base plate (B) and turn in screws (C) with provided allen tool (D) until securely tightened.
1. Connecting base to main body :
2A. Select the appropiate foam pad (E) according to the thickness of your tablet (or tablet in its case), then press adhesive side into center
of the tablet holder. As shown above.
- Use this table to determine the appropiate
foam pad (B) to use with your tablet.
Note: sizes refer to total tablet size with or
without a case
Tablet Thickness:
Foam Pad
Thickness:
1mm 0.67-1.06in / 17-27mm
0.51- 0.91in / 13-23mm
0.31- 0.71in / 8-18mm
5mm
10mm
E
A
1mm
5mm
10mm
E
Foam Pads
x3
1mm
5mm
10mm
D
x1
x1
A
x1
B
C
x3
x3
B
CD
A

888-733-4448
3. Inserting Tablet to Holder
4. Adjustable angles :
5. Cable management :
5A. Identify the hole at the bottom to where cable routing should go and then fish the cord through the base out the top to properly tuck away cord
as shown above.
4C. Locate screw on the back of pole
then turn clock-wise to prevent rotation.
**Tablet shown for example and NOT INCLUDED
4A. For landscape or portrait setups,
rotate the holder (B) as shown above.
B
4B. For forward or backwards setups,
tilt the holder (B) as shown above.
B
4A. Press quick release button (1) on side of tablet
holder (A) to release the adjustable end.
4B. Insert tablet corner against the spring arm. Push adjustable arm down
against opposite corner (A). Be sure it is as snug as possible.
**Tablet for illustration
only and not included
AA
A
(1)
D