CTA ADD-PARAFS User manual

x4
x4
x1 x1
x4
x4
x8
INSTALLATION:
1A. Align the holes of the body (A) to the
base plates (B) as illustrated. Rotate in
(4) screws (G) using provided tool (J)
until securely tightened.
1. Mounting Base to Body
PACKAGE CONTENTS:
x4 x1
2. Setting up Cable Routing
2A. Using the provided weighted pendant, route the cable through the stand. You must first remove the VESA adapter
using provided allen tool to unscrew. Using the pendant tool (C), affix/tie the cable first, then fish it through the large hole
at the top, drop it through the body and fish the cable through until it has come out the backside hole as illustrated. After,
reattach the VESA adapter with screws (G) and provided tool. Make sure to pull cable through hole before you reattach
as illustrated above.
**Cable for device for
illustration and not
included
3. Adjusting VESA Adaptor
3A. Using provided tool (F),
rotate clockwise to lock
VESA adapter in place.
Rotate counterclocwise to
loosen and flex the adapter
for flexibility when VESA
compatible item is installed.
x1
CTA Digital Floor Stand Component
For Kitting
ADD-PARAFS / ADD-PARAFSW / ADD-PARAFSS
INSTRUCTION - MANUAL

4. Setting up VESA Compatible Items
x4 **Enclosure and cable
for illustration and not
included
4A. Align the VESA holes of the body (A)
to the holes of your VESA compatible
device as illustrated. Rotate in (4) screws
(H) using provided tool (J) until securely
tightened.
x4
x4
5. Anchoring Base (Optional)
5A. Pre-drill holes into the surface aligning with
floorstand drill holes using drill (not included). Insert
anchors first into holes (E), and drill in screws from
top until securely fastened. If not screwing into
surface, using fillers (D) to plug into holes for a
seamless finish.
**Tablet for illustration
and not included
6. Removing VESA Adaptor for Monitor Setup
6A. Located the endcap piece on the side of VESA adaptor as illustrated and
remove with fingers. Using provided tool (F), loosen sides as shown. Remove the X
VESA center component
7. Attaching Monitor and Reassembling
7A. Align the now removed X VESA component with the VESA holes on
the back of your monitor. Rotate in the screws (I) using provided allen
key tool until securely tightened.
7B. WITH the X VESA attached to the monitor, place the entire setup
back onto the floor stand body. Align the VESA joint with the original hole
as shown above. Then using the provided tool, tighten the now
connected VESA joint. Place in the fillers for a seamless look afterwards.
**Monitor for
illustration and not
included
**Monitor for
illustration and not
included
x4