CUBE in-a-box V3 Series User manual

- 1 -
Cube in-a-Box – V3.series – Assembly Instructions
1
Unpack all the parts, check
quantities with the packing
list. If there is a problem
with the count, call our
customer service at
1-888-880-2823 (Pacific
Time)
or email at
[email protected]
2
Slide panel 1T * (24”W) in
between end-post A (37”H),
and a 2-way post B (57”H).
Then slide half-panel 2
(36”W) in between post B
and linear-post C (57”H).
*TIP 1: letter T is for panels
with a pre-installed alu cap.
3
Slide other half-panel 2
(36”W) in between post C
and second 2-way post B.
Slide panel 3 (36”W) in
between 2-way post B and
second linear-post C.
4
Slide panel 3T (36”W) in
between linear-post C and
2-way post D (37”H).
Slide other panel 1T (24”W)
in between 2-way post D
and other end-post A.
5
Use a rubber hammer and
make sure all panels are
pushed all the way down.

- 2 -
6
Slide raceway-panels 4 on
top of the half-panels 2.
7
Slide rail-panels 5 ** on top
of the raceway-panels.
**TIP 2: Rail-panels must be
installed with hooks facing
up so paper and pencil
trays can hold on them.
8
Slide panels 3T (36”W) on
top of the rail-panels 5.
9
Slide whiteboard-panel 6T
(marker board) on top of th
e
last rail-panel 5.
10
Assemble the 2 wire-guides
and slide/adjust them into
posts where you will need
them, preferably under
work top level.
11
Check and assemble all
brackets and cantilevers.
Use big chromed-screws
here.
12
Adjust the brackets and
cantilevers to the mark leve
l
(dot) on each post.
Cantilevers go on linear
posts C, brackets go on all
other posts.

- 3 -
13
Repeat for all brackets and
cantilevers.
You just need to tighten the
big chromed- screw to
make it hold.
14
Display brackets on all
corners and on all end
posts.
15
Insert each fillers to hide
the empty space at end of
posts B and C, as per
pictures.
16
Display the raceway-cap by
adjusting at the bottom into
the black plastic molded
piece on each side, and
then by pressing on top of
each side into the frame.
17
Use a leveler to adjust all
the work-tops and brackets.
You may use an electric dril
l
from underneath to screw
the tops. Use the black
wood-screws here.
18
Check and assemble the
two shelf-supports with the
big chromed-screws.
Slide each support into the
posts where you want the
shelf to be displayed.
19
Adjust both shelf-supports
at the height of your choice
.

- 4 -
20
Display the shelf on top of
the shelf-supports, then
push vertically on each of
the black plastic brackets
until it fits in.
21
Push the shelf against the
panel.
Display the book-holders a
s
per the holes.
Use a leveler to adjust the
shelf-supports height.
22
Place all the metal-caps on
top of each post, then use a
screw driver to tighten the
m
with the flat self tapping
metal-screws.
23
Place magnet plastic-caps
on top of each post.
Place the grommet-cap on
the work-top hole.
24
YOU ARE DONE!!