Cudy POE300 User manual

Quick Installation Guide
Model: POE300
EU declaration of conformity
Cudy hereby declares that the device is in compliance with the
essential requirements and other relevant provisions of directives
2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.The
original EU declaration of conformity may be found at
http://www.cudy.com/
CE Mark Warning
This is a class B product. In a domestic environment, this product
may cause radio interference, in which case the user may be
required to take adequate measures.
Indicators
System Indicator: AC Power
User Indicator: Channel Power
Connectors
Protection
Shielded RJ-45, EIA 568A and 568B
Over voltage protection
Anti-interference protection
Operating Temperature: 0 to 40℃
Operating Humidity:Maximum 85%
Storage Temperature:-40 to 60℃
Environmental
Conditions
Over current protection
Over load protection
Model
Output Voltage
PoE Power
Pin Polarity
POE300
Standard
1/2(-)3/6(+),4/5(+)7/8(-)
802.3af/at/bt
Data Rates 10/100/1000Mbps
Input Power
Requirements
Dimensions 168mm x 73.5mm x 44mm
53VDC
30W&60W max
AC Input Voltage: 100 to 240 VAC
AC Input Current: 0.5A 100-240 VAC
AC Frequency: 50 to 60 Hz
Specifications
4
For support and warranty, please visit: http://www.cudy.com/.
Specifications are subject to change without notice. Cudy is a
registered trademark of Shenzhen Cudy Technologies Co., Ltd.
Other brands and product names are trademarks or registered
trademarks of their respective holders.Copyright©2020
Shenzhen Cudy Technology Co., Ltd. All rights reserved.
EU Address: Otto esser 2c, 65451 Kelsterbach, Germany
810600065

Power Socket
Ethernet Device
(switch, router, etc.)
1 2 3 4 5
Wireless AP Smart VoIP
IP Camera
PoE 300
Powered Device (PD)
Hardware Connection
1
Power
Mode A
Mode B
DATA/INPoE/DATA
AC Socket
Physical Appearance
2
PoE/DATA DATA/IN
Power
Mode A
Mode B
INPUT 100-240VAC
LED and Interface Explanation
3
Data/PoE
Mode A 1/2(-)3/6(+) Power output
Mode B 4/5(+)7/8(-) Power output
AC Socket
DATA/IN
PoE/DATA
Connect with AC cable
Connect to the Ethernet device with
CAT5E or CAT6 UTP cable to transmit data.
Connect to the camera with UTP cable
CAT5E or CAT6 supply power
PoE injector got 100-240V
power input