Cuisinart CPS-100 Series User manual

INSTRUCTION BOOKLET
For your safety and continued enjoyment of this product, always read the
instruction book carefully before using.
Baby Portable UV Sterilizer CPS-100 Series

2
IMPORTANT
SAFEGUARDS
1. READ ALL INSTRUCTIONS BEFORE USING THE
APPLIANCE.
2. KEEP OUT OF THE REACH OF CHILDREN.
3. DO NOT SUBMERGE IN WATER OR ANY TYPE
OF LIQUID.
4. DO NOT LOOK AT UV LIGHT WHILE IN
OPERATION.
5. DO NOT USE IF BROKEN OR DAMAGED.
6. DISPOSE OF BATTERIES AND UNIT
ACCORDING TO LOCAL LAWS.
7. DO NOT USE WHILE BATHING. NEVER USE
WHILE SLEEPING OR DROWSY.
WARNING: To reduce the risk of re, electric
shock, or injury:
1. Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
2. Use only as described in this manual. Use only
manufacturer’s recommended attachments.
3. WARNING - This cover is provided with an interlock
to reduce the risk of excessive ultraviolet radiation.
Do not defeat its purpose or attempt to service
without removing

3
SAVE THESE
INSTRUCTIONS
Declaration of conformity to the applicable provisions of
applicable US Federal requirements, including 21 CFR,
Chapter 1, Subchapter J, Radiological Health.
FOR HOUSEHOLD
USE ONLY
STERILIZER USE INSTRUCTIONS:
1. Insert 3xAAA alkaline batteries into battery
compartment (look for the symbol on unit for
correct battery placement).
2. Open door by sliding the front cover from left
to right.
3. Insert pacier into clips located inside unit cavity
and/or remove clips by grabbing and pulling rubber
clips out of unit to insert objects like bottle nipples
and other baby accessories.
4. Close door.
Note: To re-insert clips: Hold the rubber clip so the
word “UP” is parallel to the side wall of the unit.

4
Insert the “T” section of rubber clip into the square
hole in the back of the chamber. Rotate and twist
the rubber clip so that the word is up and the angle
section faces inward.
5. Press and hold the side button for 2 seconds to
begin process. The LED light stays on.
6. The sanitizing process will take up to 6 minutes.
Note: It may take up to 30 seconds for bulb to
illuminate.
7. During the sanitizing process, unit automatically
shuts off when door is open.
8.
Unit automatically shuts off when cycle is complete.
9. Press and hold the button for 2 seconds to end the
process.
10. Three quick blinks followed by a 3-second pause
indicates the batteries are low.
11. Any other services should be performed by an
authorized service representative.
CLEANING DIRECTIONS:
To clean inside unit:
1. Use a damp cloth to wipe down all internal surfaces
of unit. Use water only.
2. DO NOT Immerse in water.