
OPERATION
Model MF3800
Page 14 CumberlandStoveWorks.com
ELECTRIC IGNITION INSTRUCTIONS
IMPORTANT:
NOTE: The stove has been designed with a safety switch on the
hopper lid. The auger will not run with the hopper door open.
NOTE: Pre-loading the repot isn’t necessary for electric
ignition; the program is designed to automatically load the
repot. The noises you will hear during electric ignition are
the combustion fan and air pump running. DO NOT overload
the repot. Doing so can cause a violent ignition.
STARTING FIRE AND ELECTRIC IGNITE SCREENS
NOTE: the feed auger will stay on for one minute or until the
ADD FUEL button is pressed again.
and
NOTE: Hot stoves need air circulating through them at
all times to prevent overheating the electronic controls.
Therefore, once proof of re is made, the convection fan will
continue to run. Fan speed increases with level increase. At
Level 6, it cannot be turned down.
RANGE 1-4
LEVEL 1-6
NORMAL OPERATION
NOTE: if the stove is being controlled by the local thermostat
the TEMPUP and TEMPDOWN buttons controlthe thermostat
setpoint. If the stove is being controlled by the remote
thermostat the TEMP UP or TEMP DOWN buttons have no
eect on the heat output.
twice. This is
NOTE: The range can be changed after the ignition cycle.
Changing the range during the ignition cycle restarts the
ignition, which adds 15 minutes to the ignition time.