Current COMPASS tradeselect CCRGRC User manual

WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Combination Exit/Emergency Light
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors
2. Do not mount near gas or electric heaters.
3. Use caution when handling batteries. Avoid possible shorting.
4. Equipment should be mounted at heights (Max:9ft) to prevent tampering by unauthorized
personnel.
5. The use of accessory equipment is not recommended by the manufacturer, this may cause
unsafe conditions.
6. Do no use this equipment for other than the intended use.
7. Save these instructions
INSTALLER:
•SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
•SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
INSTALLATION
Ceiling Mounting
1. Connect 20" jumper leads to A.C. input leads in J-box, fasten J-box bracket to J-box. Use black wire for 120 volt, Red wire for 277
volt, White wire is common.
2. Fasten canopy to J-box bracket.
3. Snap housing to canopy.
4. Connect and trim input leads to socket leads at upper left comer of housing wire channel.
5. Mount two Remote lamp head at most.
6. Secure face plate to housing. Remove the proper arrow as required.
Back Mounting
1. Connect 20 "jumper leads toA.C. input leads in ]-box.Use Black wire for 120 volt,Red wire for 277 volt, White wire is common.
2. Remove necessary knockouts and fasten back cover to J-box.
3. Snap housing to back cover.
4. Connect and trim input leads to socket leads at upper left comer of housing wire channel.
5. Mount two Remote lamp head at most.
6) Secure face plate to housing.
IMPORTANT:
When relamping, only use lamps specied in the exit sign.
Using other lamp types may result in transformer damage or unsafe conditions.
The battery in this unit may not be fully charged.
After electricity is hooked up to unit, let the battery charge up for at least 24 hours, then normal operation of this unit should take effect.
Warning: Unused wires must be capped using
enclosed wire nuts.
CCRGRC/CCRGRCB/CCRG/CCRGB

RECYCLING INFORMATION
All steel, aluminum and thermoplastic
parts are recyclable.
All cartons contain recycled materials.
Please recycle responsibly.
WIRING DIAGRAMS
1. The unit is shipped from the factory with the color selector jumper set to "RED" (see gure 2 - jumper is placed
across pins 2&3) and use the red diffuser.
2. To change the color to "GREEN", move the color selector jumper to "GREEN" (see gure I -jumper is placed
across pins 1&2) and use the green diffuser.
CCRGRC, CCRGRCB CCRG, CCRGB
Operation
COMP0003
currentlighting.com/dual-lite
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
Rev 06/07/22
com_cc_instsht_R01