The BYPASS switch latches the loop ON or OFF. If the loop is active, the LED is on.
The MOMENTARY ON/OFF switch simply reverses the state of the loop while held down.
The TRAILS/PRESEND switch determines what happens when the loop is engaged or bypassed with either footswitch.
In NORMAL mode (toggle center) , the loop functions normally, it is either on or off.
In TRAILS mode (toggle up), SEND is switched.
If you switch the loop On, it will function as normal. If you switch the loop Off, the Send is muted, but the Return remains active, allowing effects
such as delay and reverb to trail off.
In PRE-SEND mode (toggle down), RETURN is switched.
If you switch the loop On, any signal introduced to the loop prior to switching will start playing, because Send was on. If you switch the loop Off,
the effects stop immediately, but are still receiving signal because Send is still on.
Examples:
TRAILS (toggle up), DELAY pedal in the loop
With the loop ON, both Send and Return are active, so you hear delay all the time.
If you switch the loop OFF, Send turns off, so no new signal is sent to the effect, but Return is still on, so delay repeats will continue and trail off.
PRE-SEND (toggle down), REVERB pedal in the loop
With the loop ON, your voice will have Reverb.
If you turn the loop OFF, the Reverb will stop immediately, because the Return is off. When you turn the loop back on, any signal sent to it prior to
turning on will then come through, since the SEND was never turned off.
MOMENTARY ON/OFF USAGE
If the loop is on, holding the MOMENTARY ON/OFF switch will turn the loop off until you let go. An example of where to use this is if you have
a delay in the loop, and usually keep it on, you can hold this switch to turn off the loop to address the audience, then let go to go back to normal
delayed vocals, eliminating the need to remember to switch the loop back on.
Toggle On/Bypass Send Return
Trails Bypass Off On
Normal On On On
Pre-send Bypass On Off
