CyberPower CRA30008 User manual

Copyright © 2016 Cyber Power Systems, Inc. All rights reserved.
USER’S MANUAL
Cable Ladder KitCable Ladder Kit
SAVE THESE INSTRUCTIONS
Please read this manual and follow the instructions for installation and use.
K01-0000558-00
Parts List
Item
A
B
C
D
E
F
G
H
I
J
Qty
2
2
4
4
8
4
4
2
2
2
Part
Ladder Components
Ladder Section (5ft/1.5m)
Assembly Hardware
Ladder Connector
M6 Phillips Pan Head Screw
Installation Hardware
Hook Bracket
M5 Flange Nut
M6 Phillips Pan Head Screw
M6 Flange Nut
Grounding Hardware
Grounding Wire
M6 Phillips Pan Head Screw
Toothed Lock Washer
CRA30008
A
B C
D E F G
H I J

Installation
Assembly
The cable ladder includes 2 sections (A). Individual sections can be used alone (5ft/1.5m), or
they can be tied together to form a longer cable ladder (10ft/3m).
To tie both sections together, use 4 x M6 screws (C) to bolt the ladder connectors (B) on to
the ladder sections (A) as shown below.
Rack Enclosure
A power cable trough (CRA30009) or a data cable partition (CRA30010) is required to be
installed on a rack enclosure prior to the installation of the cable ladder. The cable ladder can
be used to connect cable runs between rack aisles or within a rack row.
First, bolt the hook brackets (D) using the included M5 flange nuts (E) to the rivets on the
cable ladder as shown below.
Installing Cable Ladder Across Rack Aisles
Insert the ladder hooks into the slots in the power cable trough or data cable partition as
shown below.
NOTE: The cable troughs have two sets of slots at different heights. Install the cable ladder using the
slots best suited for your application.
Power Cable Trough Data Cable Partition
B
C
C
A
A
D
E

Installing Cable Ladder Within Rack Row
Screw the ladder hooks on to the power cable trough using the existing M6 screws as
shown below.
NOTE: Cable ladder installation within a rack row can only be done with the use of power cable
troughs (CRA30009).
Install on Open Frame Rack
To install the cable ladder on an open frame rack, place one end of the ladder on top of
the rack and use the M6 screws (F) with the M6 flange nuts (G) to secure the ladder as
shown below.
F
G
NOTE: For safety the cable ladder should always be installed between racks of the same height.

Cyber Power Systems, Inc.
www.cyberpower.com
For USA and Canada:
4241 12th Ave East, Suite 400
Shakopee, MN 55379
Toll-free: [phone]
For all other regions:
Please visit our website for local contact information.
Copyright © 2016 Cyber Power Systems, Inc. All rights reserved. K01-0000558-00
Ground Connection
1. To ground the cable ladder, screw the included grounding wire (H) using an M6 screw (I) and
toothed lock washer (J) to the pre-installed rivet nut on the cable ladder as shown below.
2. Connect the other end of the grounding wire to the ground screw on the power cable trough
or data cable partition. Secure the ground wire using the existing M6 flange nut as shown
below.
I
H
J