Cyfre CA819 User manual
CA819
Dual Band Amplifier Installation Manual Page 1 of 2
All brands and trademarks are the property of their respective owners.
Copyright 2007, Janizary Holdings, Inc. All rights reserved.
Rev F D00000415
Designed and manufactured in North America
Manufactured under license from Motorola Inc.
Note: Before installing the Cyfre™Amplifier, please read the entire contents.
Section # 1 Parts List
Item Qty Description
1 1 Cyfre™ Amplifier
2 1 Cyfre™ External Magnetic Mount Antenna with
10ft low loss cable &$.LWRQO\
3 1 Nylon Ballistic Bag &$.LWRQO\
4 1 Cyfre™ 12 Volt Cigarette Power Adapter &$.LWRQO\
5 1 Cyfre™ 4ft Hardwire Power Cable
6 1 Cyfre™ AC/DC Adapter&$.LWRQO\
Section # 2 Tools and Other Materials Required
Item Description
1 Electric drill (as required for signal amplifier mounting holes)
2 Screw driver
3 Qty 4 screws (length and type as required for signal amplifier mounting)
4 Wire cutters / strippers
5 Qty 2 wire connection insulators or insulating material (as required for DC power cable connection to 12V DC system)
Section # 3 WARNINGS!
∇ Antenna must be mounted a MINIMUM distance of 50 cm (1.64ft) away from any person.
∇ An external antenna must be mounted outside the vehicle, if mounting an external antenna on the exterior portion of the outside glass a minimum
of 3 feet of separation is needed. Failure to do so may result in amplifier failure will void your warranty.
∇ UNDER NO CIRCUMSTANCES CAN AN EXTERIOR ANTENNA BE INSTALLED INSIDE A VEHICLE. Doing so will result in amplifier
failure will void your warranty.
∇ The power supply must be plugged into a 12 Volt outlet tha t is connected to the fuse box of your vehicle and have a minimum o f 3 amp
fuse.
∇ Under no circumstances should you power up your amplifier without first properly connecting a 50 ohm 800/ 1900 MHz
dual band cellular antenna to both the internal and external antenna connectors. Failure to properly connecting the
antennas may result in amplifier failure will void your warranty.
∇ For optimum performance and compatibility with your service provider requirements, it is recommended that the
external antenna be installed on the exterior metal roof of your vehicle.
∇ Use of cellular amplifiers with antennas of higher gain than 6dBi gain is in violation of FCC regulations for
which the offender will be fully liable, and void your warranty.
∇ Do not combine the ext ernal or interior ant enna cable with other coaxial cables. The additi onal loss of the cable length and connectors
could greatly diminish the performance of the amplifier.
***It is recommended that only qualified or informed installation technicians install this product permanently to a vehicle.
Installation by any other person is at the risk of the owner and operator.
It is recommended that only certified automotive installation technicians install this product in a vehicle. Installation by any other
person is at the risk of the vehicle owner and operator.
Section # 4 Installation: Selecting a Suitable Location to Mount the Signal Amplifier
∇ Antenna must be mounted a minimum distance of 50 cm (1.64ft) away from any person(s).
CA819
Dual Band Amplifier Installation Manual Page 2 of 2
All brands and trademarks are the property of their respective owners.
Copyright 2007, Janizary Holdings, Inc. All rights reserved.
Rev F D00000415
Designed and manufactured in North America
Manufactured under license from Motorola Inc.
∇ You ma y place your amplifier a nywhere inside your vehicle (e xcept as mention ed above). Th e amplifier’s location should be e asily
accessible and mounted away from moving parts, excessive heat or moisture.
∇ The exterior antenna must be mounted outside the vehicle and at a distance that can be reached from the supplied antenna cable.
Section # 5 Installation Cautions
∇ Use caution to avoid drilling through or near fuel lines or fuel tanks; brake lines; or electrical wiring.
∇ Do not mount the amplifier or its associated wiring in a location that may interfere with the safe operation of the vehicle.
∇ If the fuse is changed from the 3 amps to a higher rating the warranty is void. Purchaser of the amplifier would be responsible for
the repair of the unit.
∇ Caution: Connection to the negative side with the positive lead will cause damage to the amplifier.
Section # 6 Installation of In-Vehicle Amplifier
To meet the FCC Exposure Guidelines, the antenna should be installed so there is at least 20 cm of separation between the body of the user
or nearby persons and the antenna.
Typical Installation For Under the Seat Mounting
1. For safety, disconnect the vehicle’s negative “−“battery terminal to remove power from the vehicle.
2. Drill holes and mount the signal amplifier (ITEM 1) in the selected location.
3. Connect the red w ire of the suppl ied 2 Meter (78”) power cable (ITEM 2) for the sig nal amplifier to a positive connection on the vehicle’s
electrical system. Choose a 10 t o 30 Volt DC circuit that is: fuse protected; and i gnition sw itched. (Often refe rred to as the “Accessory
output”)
4. Attach the solid black wire of the supplied 2 Meter (78”) power cable (ITEM 2) to a vehicle electrical ground point.
5. Attach an external antenna cable (6dbi max) to the amplifier's antenna connector. The “Phone” connector on the amplifier is connected to a
cellular phone handset via a RF cradle or an RF cable. Y ou ma y also connect th e optional RF cable for your han dset, from the ce llular
handset to amplifier port labelled “Phone”.
6. Reconnect the vehicle’s negative “−“ Battery terminal.
Section # 7 Limited Warranty
Cyfre™ warrants that this product is free from any defects in material or workmanship for a period of one year. If a defect in
material or workmanship is found, Cyfre™ agrees to repair or replace the product at its own discretion, free of charge, to the
original purchaser excluding all shipping charges. To return product, all parts, packaging, and accessories along with original
receipt from where you purchased your product must be included with your return. Failure to return all product, parts,
packaging, and accessories will result in voiding your warranty. The warranty is void if the product has been modified,
abused, tampered with, or subjected to abnormal conditions. Any use of non Cyfre™ antennas or cables will void your
warranty.
wpsantennas.com · 7389 Airport View Drive SW · Suite 200 · Rochester, MN · 55902 · tel:507-282-8484 · fax:866-827-4052 [email protected]
Use a 3dB
antenna for
Optimal
Performance
Table of contents
Other Cyfre Amplifier manuals
