CYP CH-1109TXC User manual

CH-1109TXC & RXC
HDMI to CAT5e/CAT6 with LAN/PoE/& IR Extender
Operations Manual
Operations Manual

3
DISCLAIMERS
The information in this manual has been carefully checked and
is believed to be accurate. Cypress Technology assumes no
responsibility for any infringements of patents or other rights of third
parties which may result from its use.
Cypress Technology assumes no responsibility for any inaccuracies
that may be contained in this document. Cypress also makes no
commitment to update or to keep current the information contained
in this document.
Cypress Technology reserves the right to make improvements to this
document and/or product at any time and without notice.
COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or any of its part translated
into any language or computer le, in any form or by any means—
electronic, mechanical, magnetic, optical, chemical, manual, or
otherwise—without express written permission and consent from
Cypress Technology.
© Copyright 2011 by Cypress Technology.
All Rights Reserved.
Version 1.1 August 2011
TRADEMARK ACKNOWLEDGMENTS
All products or service names mentioned in this document may be
trademarks of the companies with which they are associated.

4
SAFETY PRECAUTIONS
Please read all instructions before attempting to unpack, install or
operate this equipment and before connecting the power supply.
Please keep the following in mind as you unpack and install this
equipment:
• Always follow basic safety precautions to reduce the risk of re,
electrical shock and injury to persons.
• To prevent re or shock hazard, do not expose the unit to rain,
moisture or install this product near water.
• Never spill liquid of any kind on or into this product.
• Never push an object of any kind into this product through any
openings or empty slots in the unit, as you may damage parts
inside the unit.
• Do not attach the power supply cabling to building surfaces.
• Use only the supplied power supply unit (PSU). Do not use the PSU
if it is damaged.
• Do not allow anything to rest on the power cabling or allow any
weight to be placed upon it or any person walk on it.
• To protect the unit from overheating, do not block any vents or
openings in the unit housing that provide ventilation and allow for
sufcient space for air to circulate around the unit.
REVISION HISTORY
VERSION NO. DATE(MM/DD/YYYY) SUMMARY OF CHANGE
VR0 08/03/2011 Preliminary Release
VR1 01/11/2011 Sec. 7 & 9's Placement &
Connection

5
CONTENTS
1. Introduction..............................................6
2. Applications.............................................6
3. Package Contents .................................. 6
4. System Requirements.............................. 6
5. Features....................................................7
6. Operation Controls and Functions......... 8
6.1 Transmitter...........................................8
6.2 Receiver ............................................10
6.3 D-Sub 9 Pin Denitions .....................12
7. Connection Diagram ........................... 13
8. Specications ............................................
9. Acronyms ...................................................

6
1. INTRODUCTION
The device that can make your home or ofce more efcient, the CH-
1109TXC & RXC is capable of sending HDMI (uncompressed audio/
video), 3 Ethernet connections and control (through the built-in RS-232
and IR ports) over a single CAT5e/CAT6 up to a distance of 100m (300
ft.). Even more, it is adaptor free at the receiver end.
Further, with the HDMI bypass is designed to allow instant display at
the control point. So, if you wish to make your home or ofce more
efcient, get the HDMI over Single CAT5e/CAT6 with LAN/PoE & IR
Extender and prepare to be amazed.
2. APPLICATIONS
• Household entertainment media sharing and control
• Lecture room display and control
• Showroom display and control
• Meeting room presentation and control
• Classroom display and control
3. PACKAGE CONTENTS
• HDMI to CAT5e/CAT6 with LAN/PoE/IR Transmitter
• CAT5e/CAT6 to HDMI with LAN/PoE/IR Receiver
• 1× IR Blaster
• 1× IR Receiver
• 24 V DC Power Adaptor
• Operation Manual
4. SYSTEM REQUIREMENTS
• Input HDMI source equipment such as DVD/Blu-ray player and
output display with HDMI input.
• RS232 controlled device
• Ethernet equipped device

7
5. FEATURES
• HDMI 1.4 compliant with 3D formats and 4k/2k resolution support
• Supports CEC bypass function
• Simultaneous transmission of uncompressed video and audio
(1080p@60Hz/'Deep Color) over a single CAT5e/CAT6 type cable
for up to 100 m (300 ft.).
NOTE: Tested with CAT-6E/23AWG cables, using cables of another
specication may result in a different operating distance.
• Audio support up to 7.1CH Dolby TrueHD and DTS-HD
• Connect and share up to 6 Ethernet connections at speeds up to
100 Mbps
• Various controls over HDMI, CEC, RS232 and IR
• 5Play™ convergence: HD video, audio & Control (IR and RS232)/
LAN/PoE
• Installation friendly
• Single power supply powers both units, receiver unit is powered
through the transmitter.

8
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter
RearFront
PowerDC 24V
Extender
Blaster RS232 In CAT5e/6 Out
Link
IR 2
IR 1
1 2 3 4 5 6 7
HDMI
Bypass HDMI In
LAN 1 LAN 2 LAN 3
810
91010
1
Power LED
The red LED will illuminate when the 24 V DC Adaptor is connected
to the AC outlet.
DC 24V
This slot is where you plug the 24 V DC power supply into the unit
and connect the adaptor to an AC outlet.
3
IR 1 Blaster
Connect the IR blaster cables included in the package for IR signal
transmission.
4
IR 2 Extender
These slots are to connect with the IR receiver cables included in
the package for IR signal reception.
5
RS-232 In
This slot is to connect with PC/laptop with D-Sub 9-pin male cable
for sending RS-232 commands.
6
Link LED
This yellow LED will illuminate when the both CAT5e/6 input and
output signals are connected.
7
CAT5e/6 Out
Connect the transmitter and receiver via a single CAT5e/6 type
cable for all data transmission.
8
HDMI Bypass
Connect to a HDMI TV/monitor for instant display of the HDMI input
source signal.
2

9
NOTE: When the HDMI bypass is connected, no signals will be
transmitted to the receiver side. Therefore, unplug this connection
after conrming that the correct image is displayed
9
HDMI In
Connect to the HDMI equipped source equipment such as DVD or
Blu-ray player.
10
LAN 1/2/3
The LAN connections can be used to connect and share up to
6 ethernet connections (3 at the reciver end, 3 at the transmitter
end), including computers, routers and media servers.

10
6.2 Receiver
LAN 1 LAN 2 LAN 3
HDMI Out
7 8 8 8
Rear
Power
Extender Blaster
IR 2
IR 1 RS232 Out CAT5e/6 In
Link
2
1
3
4
5 6
Front
1
Power LED
The red LED will illuminate when the 24 V DC Adaptor is connected
to the AC outlet.
2
IR 1 Extender
These slots are to connect with the IR receiver cables included in
the package for IR signal reception.
3
IR 2 Blaster
Connect the IR blaster cables included in the package for IR signal
transmission.
4
RS-232 Out
Connect to a device that can be controlled (via D-Sub 9-pin
female cable) by RS-232 commands.
5Link LED
This yellow LED will illuminate when the both CAT5e/6 input and
output signals are connected.
6
CAT5e/6 IN
Connect the transmitter and receiver via a single CAT5e/6 type
cable for all data transmission.
7
HDMI Out
Connect to a HDMI equipped TV or monitor to display the HDMI
input source signal.
8
LAN 1/2/3
The LAN connections can be used to connect and share up to
6 ethernet connections (3 at the reciver end, 3 at the transmitter
end), including computers, routers and media servers.

11
6.3 D-Sub 9 Pin Denitions
Pin Dene TX/RX
1N/C
2TxD / RxD
3RxD / TxD
4N/C
5GND
6N/C
7N/C
8N/C
9N/C

12
7. CONNECTION DIAGRAM
PowerDC 24V
Extender
Blaster RS232 In CAT5e/6 Out
Link
IR 2
IR 1
HDMI
Bypass HDMI In
LAN 1 LAN 2 LAN 3
Power
Extender Blaster
IR 2
IR 1 RS232 Out CAT5e/6 In
Link
LAN 1 LAN 2 LAN 3
HDMI Out
PC
Media Server
Notebook
Media Player
TV/Display
RS232 Controlled
Device
Blu-ray/DVD Player
Modem/Router
Transmitter
PC with RS232
Control
Receiver
Single CAT5e/6 Cable

13
8. SPECIFICATIONS
Maximum Data Rate 10.2 Gbps
Resolution Range Deep Color
Ethernet Speed 100 Mbps
Transmitter
Input 1 × HDMI , 3 × Ethernet,
1 × RS-232, 1 × IR Extender
Output 1 × CAT5e/6, 1 × HDMI Bypass, 1 × IR Blaster
Receiver
Input 1 × CAT5e/6, 1 × IR Extender
Output 1 × HDMI, 1 × RS-232, 3 × Ethernet, 1 × IR
Blaster
ESD Protection Human Body Model: ±8kV (air-gap
discharge)
±4kV (contact
discharge)
IR Frequency Rate 20~60 kHz
Power Supply 24 V/1.25 A DC (US/EU Standards, CE/FCC/
UL certied)
Dimensions 125 mm(W) x 127 mm (D) x 30 mm (H) Each
Weight Tx: 360 g, Rx: 382 g
Chassis Material Aluminum
Silkscreen Color Black
Power Consumption Tx: 6 W: Rx: 8 W
Operating Temperature 0˚C ~ 40˚C / 32˚F ~ 104˚F
Storage Temperature −20 ˚C ~ 60 ˚C / −4˚F ~ 140 ˚F
Relative Humidity 20~90 % RH (non-condensing)

14
9. ACRONYMS
ACRONYM COMPLETE TERM
CAT6 Category 6 Cable
HDMI High Denition Multimedia Interface

15
NOTES:

16

Home page: http://www.cypress.com.tw
CYPRESS TECHNOLOGY CO., LTD