D-Link KVM-121 User manual

KVM SWITCH
Quick Installation Guide+
Руководство по быстрой установке+
Guía de Instalación Rápida+
Guia de Instalação Rápida+
快速安裝指南+
Petunjuk Pemasangan Cepat+
WIRED
KVM-121

Install Guide
KVM-121
KVM Switch

3
System Requirements
• PS/2 keyboard
• PS/2 Mouse
• Speakers or Headphones
• VGA or Higher Monitor
2 Sets of KVM Cables
Package Contents
D-Link KVM-121
KVM Switch
System Requirements
If any of the above items are missing, please contact your reseller.
Quick Install Guide

4
Hardware Overview
Hardware Overview
Audio Jack
VGA Port
Keyboard Port
Mouse Port
KVM Cables
Plug the cables from your keyboard, monitor, sound card, and mouse into the KVM
switch, and plug the supplied cables from your KVM switch into your computers.
Select Button
Press the select button to switch quickly and easily between both computers.

5
Hardware Overview
The KVM-121 is assembled with the supplied KVM cables fastened
to the PC 1 and PC 2 ports. Plug the cable from PC 1 into your rst
computer (Computer 1), and plug the cable from PC 2 into your second
computer (Computer 2).
PC1
Connect the audio and VGA cable to your rst
computer (Computer 1).
PC2
Connect your audio or VGA cable to your second
computer (Computer 2).

6
Hardware Installation
Hardware Installation
Attach your headphone or speakers
to the green audio jack located on
the KVM-121.
Attach your monitor’s 15-pin VGA
connector to the blue VGA port
located on the KVM-121.
Attach your computer’s 6-pin PS/2
male keyboard connector to the
purple keyboard port located on the
KVM-121.

7
Hardware Installation
Attach your computer’s 6-pin PS/2
male mouse connector to the green
mouse port located on the KVM-121.
Note: Make sure that all your computers are turned OFF before
installing the KVM-121 to avoid mouse and keyboard errors when
booting up your computers.

8
Hardware Installation
The following steps apply to both computers that will be used with
the KVM-121. Start by attaching the cables connected from the PC
1 port of the KVM-121 to Computer 1.
Connect the KVM-121’s included
monitor cable (blue coated) to the
VGA port located on the back of your
computer case.
Plug the KVM-121’s included
keyboard cable (purple coated) to
the PS/2 keyboard port located on
the back of your computer case.
Plug the KVM-121’s included mouse
cable (green coated) to the PS/2
mouse port located on the back of
your computer case.

9
Hardware Installation
Plug the KVM-121’s included audio
cable to the audio jack located on the
back of your computer case.
Note: Repeat these steps to attach
the cables connected from the PC 2
port of the KVM-121 to Computer 2.
Power ON both of your attached computers after you have completed
the KVM-121 installation.
Once you’ve completed your KVM-121 installation, your connections
may appear similar to the diagram below.

10
Switching the KVM-121
You can use your keyboard to switch between your computers. Press
and hold the Scroll Lock key twice to enter the Hot Key switching mode.
A beep conrms that the Hot Key switching mode is activated.
Switching the KVM-121
Hot Key Menu
Scroll Lock + Scroll Lock + 1 : Switches to PC1 only.
Scroll Lock + Scroll Lock + 2 : Switches to PC2 only.
Scroll Lock + Scroll Lock + F1 : Switches to PC1 with audio
signal synchronously.
Scroll Lock + Scroll Lock + F2 : Switches to PC2 with audio
signal synchronously.
Scroll Lock + Scroll Lock + → : Switches to the next PC
with audio signal synchronously.
Scroll Lock + Scroll Lock + ← : Switches to the previous PC
with audio signal synchronously.
Scroll Lock + Scroll Lock + B : Enable/Disable Beep.
Scroll Lock + Scroll Lock + M : Resets the mouse and keyboard.
Scroll Lock + Scroll Lock + S : Auto-Scan Mode automatically
switches between computers
every 10 seconds (Monitor Only).
Spacebar : Exits Auto Scan Mode.

11
Troubleshooting
Keyboard
If your keyboard is not functional, not detected, or there is a keyboard
error on boot-up, check the following:
• Make sure that the keyboard is properly connected to the
KVM-121. Check that the purple coated keyboard cable is securely
plugged into the correct PS/2 keyboard port (purple colored) and
not the PS/2 mouse port (green colored).
• Verify that the keyboard works when plugged into the computer
directly. You will have to shut down your computer rst to do
this.
• Read your motherboard documentation and make sure that
the PS/2 keyboard’s IRQ is enabled. This can be set for most
computers in the BIOS setup.
• Try using a different keyboard.
Mouse
If your mouse is not functional, not detected, or there is a mouse error
on boot-up, check the following:
• Make sure that the mouse is properly connected to the KVM-121.
Check that the green coated mouse cable is plugged into the
correct PS/2 mouse port (green colored) and not the PS/2
keyboard port (purple colored).
• Verify that the mouse works when plugged into the computer
directly. You will have to shut down your computer rst to do
this.
• Read your motherboard documentation and make sure that the
PS/2 mouse’s IRQ is enabled. This can be set for most computers
in the BIOS setup.
• Try using a different mouse.
• If mouse movement is random when switching between computers,
try shutting down your computer and rebooting.
• Verify that your computers do not have more than one mouse
Troubleshooting

12
Troubleshooting
driver installed (check your cong.sys and autoexec.bat les for
Windows) and that you are using the latest mouse driver.
• If a special mouse is used such as a cordless or scrolling mouse,
make sure you use generic PS/2 mouse drivers. A non-standard
PS/2 mouse may have extensions on the PS/2 protocol that are
not supported by the KVM-121.
• Do not move the mouse or press any mouse buttons when
switching from one PC to another.
• Try resetting the mouse by unplugging it from the KVM-121 for
about 3 seconds and then reconnect.
Video
If the image on your monitor is not clear, check the following:
• Verify that all video monitor cables are inserted properly. Make
sure that the blue coated VGA cable is connected to your computer
and that the black coated cable is connected to the KVM-121.
• Try lowering the resolution and refresh rate of your monitor.
• Try using a shorter video cable.
Audio
If your audio is not functional properly check the following:
• Make sure that the speakers are properly connected to the KVM-121.
Check that the green coated audio cable is plugged into the correct
audio jack (green colored).
• Verify that the speaker works when plugged into the computer
directly.
• Try using a different set of speakers.

Notes

Technical Support
You can nd software updates and user documentation on the D-Link website.
Tech Support for customers in
Australia:
Tel: [phone]
Monday to Friday 8:00am to 8:00pm EST
Saturday 9:00am to 1:00pm EST
http://www.dlink.com.au
e-mail: [email protected]
India:
Tel: [phone]
Monday to Friday 9:30AM to 7:00PM
http://www.dlink.co.in/support/productsupport.aspx
Indonesia, Malaysia, Singapore and Thailand:
Tel: [phone] (Indonesia)
Tel: [phone] (Malaysia)
Tel: [phone] (Singapore)
Tel: [phone] (Thailand)
Monday to Friday 9:00am to 6:00pm
http://www.dlink.com.sg/support/
e-mail: [email protected]
Korea:
Tel: [phone]
Monday to Friday 9:00am to 6:00pm
http://www.d-link.co.kr
e-mail: [email protected]
New Zealand:
Tel: [phone]
Monday to Friday 8:30am to 8:30pm
Saturday 9:00am to 5:00pm
http://www.dlink.co.nz
e-mail: [email protected]

Technical Support
You can nd software updates and user documentation on the D-Link website.
Tech Support for customers in
Egypt:
Tel: [phone] or [phone]
Sunday to Thursday 9:00am to 5:00pm
http://support.dlink-me.com
e-mail: [email protected]
Iran:
Tel: [phone]
Sunday to Thursday 9:00am to 6:00pm
http://support.dlink-me.com
e-mail: [email protected]
Israel:
Tel: [phone]
Sunday to Thursday 9:00am to 5:00pm
http://www.dlink.co.il/support/
e-mail: [email protected]
Pakistan:
Tel: [phone] or [phone]
Sunday to Thursday 9:00am to 6:00pm
http://support.dlink-me.com
e-mail: [email protected]
South Africa and Sub Sahara Region:
Tel: [phone]
08600 DLINK (for South Africa only)
Monday to Friday 8:30am to 9:00pm South Africa Time
http://www.d-link.co.za
Turkey:
Tel: [phone]
Monday to Friday 9:00am to 6:00pm
http://www.dlink.com.tr
e-mail: [email protected]
e-mail: [email protected]
U.A.E and North Africa:
Tel: [phone] (U.A.E)
Sunday to Wednesday 9:00am to 6:00pm GMT+4
Thursday 9:00am to 1:00pm GMT+4
http://support.dlink-me.com
e-mail: [email protected]

Руководство по быстрой установке
KVM-121
Переключатель KVM

17
System Requirements
• Клавиатура PS/2
• Мышь PS/2
• Динамики или наушники
• Монитор VGA или выше
2 набора кабелей KVM
Содержимое комплекта
Переключатель KVM
D-Link KVM-121
Системные требования
Если что-либо из перечисленного отсутствует, обратитесь к Вашему
поставщику.
Руководство по быстрой
установке

18
Hardware Overview
Описание оборудования
Гнездо для
подключения
наушников
Порт VGA
Порт для
клавиатуры
Порт для мыши
Кабели KVM
Подключите кабели клавиатуры, монитора, звуковой карты и мыши к
переключателю KVM, а кабели переключателя KVM, входящие в комплект
поставки к компьютеру.
Кнопка Select
Нажмите на кнопку Select, чтобы быстро и легко переключиться между
обоими компьютерами.

19
Hardware Overview
KVM-121 оснащен кабелями KVM, включенными в поставку,
закрепленными на портах PC1 и PC2. Подключите кабель от PC1
к первому компьютеру, а кабель от PC2 ко второму компьютеру.
PC1
Подключите аудио - и VGA- кабели к первому
компьютеру.
PC2
Подключите аудио - и VGA- кабели ко второму
компьютеру.

20
Hardware Installation
Установка оборудования
Подключите наушники или
динамики к зеленому гнезду
для подключения наушников,
расположенному на KVM-121.
Подключите разъем 15-pin VGA
монитора к голубому разъему
порта VGA, расположенному на
KVM-121.
Подключите клавиатуру
компьютера с разъемом 6-pin
PS/2 «папа» к пурпурному порту
клавиатуры, расположенному на
KVM-121.