D-Link DGL-4300 - GamerLounge Wireless 108G Gaming... User manual

Quick Install Guide+
DGL-4300
EXISTING NETWORK > NEW NETWORK

©2004 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of
their respective holders. Software and specications subject to change without notice.
QUICK INSTALL GUIDE
MODEL: DGL-4300
Existing Network > New Network

3
Wireless Antenna
Attach the wireless antenna to the rear panel of the
DGL-4300 by turning the knob at the base of the
antenna until it is fully attached.
Vertical stacking stands are provided so you can place your
D-Link® Gaming Router in a vertical position. Rubber Feet
are provided to allow proper ventilation when the D-Link®
Gaming Router is placed horizontally or stacked upon other
D-Link® stackable products.
To attach the vertical stands, simply slide the vertical stands
into the slotted grooves on the top and bottom panels of the
D-Link® Gaming Router.
To attach the rubber feet, simply press the rubber feet
into the four corners on the bottom panel of the D-Link®
Gaming Router.
Hardware Installation
1Unplug the power from your broadband modem and
shut down your computer.
Vertical Stands and Rubber Feet
Reset
Button
Power
Receptor
Broadband
modem
Model:DGL-4300
H/WVer.:A1 F/WVer.:XX
P/N:BGL4100ANAA1
Power: SolidBlue(Connected)
WAN: SolidBlue(Connected)
LAN: SolidBlue(Connected)
BlinkingBlue(T
raffic)
MAC:Serial:
Polarity:
Input:
5V/2A
00055D9661FE53729352308745
FCCID: KA2DGL4100A1
MADEINTAIWAN
Thisdevice complieswith part 15 ofthe FCC Rules.
Operationis subjectto the following twoconditions:
(1)This device may not cause harmful interference.
(2)This device must acceptany interference received,including
interferencethat may causeundesired operation
.
(1-4)
LEDIndicators
RESET
+
-
5v 2.5A

4
6
7
8
3
2Disconnect the Ethernet cable connected from your computer
to your broadband modem. Leave the end connected to your
broadband modem attached.
Connect the end of the Ethernet cable removed from your computer
to the WAN port on the router.
4Connect the provided Ethernet cable from a numbered port on the
router to your computer.
5Plug the power back into your broadband modem and wait for the
broadband modem to sychronize to the network (refer to the Modem
manual for information on this).

5
6Plug the power adapter (provided with the router) into the router, then
connect the other end to a power outlet and verify that the POWER
LED on the router is on.
Note: If the Power LED is not lit, verify that the power adapter is
properly connected to the D-Link® Gaming Router and to a working
power outlet.
7Power on your computer.
8Verify that the WAN and LAN port (corresponding to where the
computer was connected in step 4) LED’s are on.
Note: If the WAN LED is not lit, check the connection of the Ethernet
cable from the Broadband modem to the WAN port of the D-Link®
Gaming Router as detailed in steps 2-3. If the LAN LED is not lit,
check the connection of the Ethernet cable as detailed in step 4.

6
9Launch your web browser and type in a web address such as
http://games.dlink.com to verify that you have an Internet
connection.
10 If a web address is not accessible, enter http://192.168.0.1 in
your web browser address bar. Once the main screen appears,
press the button labeled Internet Connection Setup Wizard and
proceed through the wizard.
For additional details on the Internect Connection Setup Wizard,
please refer to the User Manual on the CD-ROM.
UK: 08456 12 0003