Da-Lite CT-LS20 User manual

INSTRUCTION BOOK FOR
Computer Table Laptop
Storage Cart

2
Computer Table Laptop Storage Cart CTLS20 and CTLS30
Procedure
1. Remove contents from carton and examine.
CAUTION! The user of this product should exercise caution
when moving the cart. Any sudden stop could cause
instability of the cart and could cause serious injury and/or
damage. The cart should always be pushed, never pulled, by
the user. Always push from the side of the cart, never from
the front or back of the cart.
Required Tools:
- 1/2” end wrench
B
0.75
A
5
3
4
1
2
C
Item Description
CT-LS20
Qty
CT-LS30
Qty
1 Divider 16 24
2 Cart Assembly 1 1
3 Caster, Plate 5" W/B 2 2
4 Caster, Plate 5" 2 2
5 Package Set 1 1
A Grommet, 2" 8 8
B Bolt, HHCS 5/16"-18 x 3/4" 16 16
C Wrench, Allen 5/32" 1 1

3
2. Lay cart onto rear panel. See Figure 1. Using a 1/2" wrench, Install
Plate Casters (3 & 4) using 5/16"-18 x 3/4" Bolts (B). For maximum
braking capacity, the two brake casters should be installed
diagonally across from each other. Tighten all fasteners.
Procedure (Continued)
Figure 2b
CT-LS30
1
A
Figure 1b
CT-LS30
B
4
3
2
3. To disengage lock, insert and turn key 1/4 turn to the right.
To open latch, push inward on chrome keypad.
4. Install the dividers as needed. Install grommets. See Figure 2.
Figure 2a
CT-LS20
1
A
Figure 1a
CT-LS20
4
B
3
2

E-396
A Milestone AV Technologies Brand
3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: [e-mail]
www.da-lite.com
DL–0375 (Rev. 3) 01.16
© 2016 Milestone AV Technologies LLC. Printed in U.S.A.
Procedure (Continued)
Figure 3b
CT-LS30
Figure 4b
CT-LS30
Optional Power Strips
Figure 3a
CT-LS20
Figure 4a
CT-LS20
Optional Power Strips
5. Remove rear panel by removing the hex head screws using the
5/32" hex key (C). See Figure 3.
Note: CTLS20 has (5) hex head screws and CTLS30 has (8).
6. If power strips were ordered separately, install one on each shelf
according to the instructions provided with the power strip. See
Figure 4.
Note: If the cart was ordered as an assembly including power
strips, a strip will be pre-installed on each shelf.
7. Reattach rear panel using the (8) hex head screws removed in
the step 6. See Figure 3.