
Grill Models: AEGR30, AEGR3648,
AGDRT14 and AGRG14 INSTRUCTIONS
Cooktop and Range Models: DR30D, DRT304S, EG366, EG486
ER30D, ER30DSR, ER30G, ER30GI, ER36D and ER48D
Part No. 102331 Rev. F
WARNING: Do not touch the grill when hot.
WARNING: Do not use water on grease res. A violent steam explosion may result. Smother any
ames with a lid, cookie sheet or at tray. Use baking soda or a foam extinguisher to extinguish am-
ing grease. Be careful to avoid getting burned.
WARNING: Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate,
well-ventilated room during cooking.
CAUTION: Place the grill only in the position shown in these instructions. Do not turn the burners
under the grill higher than the MAX GRIDDLE setting. Setting the burner ames too high or putting
the grill in the wrong position may damage it permanently. Some appliances do not come with knobs
marked with the MAX GRIDDLE setting. The grill kit for these appliances comes with MAX GRIDDLE
knobs that must be installed prior to use.
(Cooktop/Range Models DR30D, DRT304S, ER30G and ER30GI Only)
Grills for the above listed cooktops/ranges come with knobs with the words MAX GRIDDLE on them. Install them
before using the grill to prevent damage. All other models come with the MAX GRIDDLE knobs already installed.
CAUTION: Putting the knobs in the wrong position may result in damage to the grill.
STEP 1 Remove the existing two knobs on the right side of the control panel. Grasp each one and pull straight
back. Leave the other two knobs in place.
STEP 2 Put the new knobs from the kit, with the words MAX GRIDDLE on them, on the valve shafts in place
of the knobs removed in step 1. When installing the knobs, align the “D-shaped” opening on the back
of the knob with the end of the valve shaft. Carefully push in on each knob until it stops. The old knobs
may be discarded.
DRT304 Cooktop DR30D Range ER30G[I] Range
Knob Installation