Dacor RO230 Technical manual

PLANNING
GUIDE
1.15
Specications subject to change without notice. Phone: [phone]www.dacor.com
RO230, ROV230
30 Inch, Double,
Renaissance®Wall Oven
(A) Overall
Width
(B) Chassis
Width
(C) Overall
Height
(D) Chassis
Height
(E) Control
Panel
Overlay
29 7/8”
(75.9 cm)
28 3/8”
(72.1 cm)
49 7/8”
(126.7 cm)
49”
(124.5 cm)
7/8”
(2.2 cm)
(F) Utility
Cutout Width
(G) Utility
Cutout Height
(H) Utility
Cutout Depth
(J) Control
Panel Depth
(K) Chassis
Depth
6 1/4”
(15.9 cm)
4 3/4”
(12.1 cm)
7 3/4”
(19.7 cm)
1 3/16”
(3.0 cm)
23 5/8”
(60.0 cm)
ELECTRICAL SPECIFICATIONS
Dedicated Circuit
Requirements Total Connected Load
240 Vac 60 Hz.,
4-wire,* 60 Amp. 11.6 kW (48.6 Amp.)
* Two 120 Vac hot (L1 and L2), one neutral, one ground.
Fuse/circuit breaker on both L1 and L2.
The above specifications are for reference only. See the
product data plate for exact specifications.
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
Document # PG01-010 Revised 10/01/11 Page 1/2
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
21 1/8”
3 1/2”
(8.9 cm)
3 3/16”
(8.1 cm)
1 1/8”
(2.9 cm)
1 1/8”
(2.9 cm)
HANDLE DIMENSIONS
Epicure Millennia (Order kit #AMOH30))
C
A
Conduit:
60” (152 cm)
Long
D
J
B
H
G
F
Top of
chassis
Utility
cutout
K
Control panel
side view
Control panel
front Top of
chassis
E

PLANNING
GUIDE
1.16
Specications subject to change without notice. Phone: [phone]www.dacor.com
30 Inch, Double,
Renaissance Wall Oven
RO230, ROV230
DOUBLE WALL OVEN - CUTOUT DIMENSIONS
(N) Minimum
Cabinet
Width
(P) Minimum
Cut Out Width
(R) Minimum
Cutout Height
30”
(76.2 cm)
28 1/2”
(72.4 cm)
49 1/8”
(124.8 cm)
Minimum interior cabinet depth: 24” (61.0 cm)
Cabinet tolerances: +1/16” (+1.6 mm) -0, unless otherwise stated
Document # PG01-010 Revised 10/01/11 Page 2/2
4” typical toe kick
Recommended
electrical
location
N
P
R
3/4” (1.9 cm)
support platform
1” (2.5 cm) min.
to bottom of
cabinet door
1” (2.5 cm) min.
to top of
drawer face
9 5/8” (24.4 cm)
recommended