dadada SOHO DRESSER User manual

SOHO
DRESSER

Soho Dresser -
Assembly Instruction
CAUTION
• Thank you for purchasing our product. Please follow
these assembly instructions as it will save you time,
make assembly easier and prevent possible damage
to your new furniture item.
• We strongly recommend that this unit is assembled
on a soft surface such as carpet or blanket.
• When moving this furniture item, always carry
the unit. Dragging or sliding the unit could damage
the unit and the oor surface.
• READ ALL INSTRUCTIONS BEFORE USE
OF THIS PRODUCT.
• KEEP THE INSTRUCTIONS FOR FUTURE USE.
• NEVER PUT BABY ON THE TOP WITHOUT
CHANGING TRAY.

rst dresser
Your
Before you start to assemble,
we highly recommend
watching our assembly
instructions video or go to our
website: dadadababy.com

Part List
×4 ×4 ×4
×6
2-11/64’’
∅8×55
2’’
M8*50
M5
AB C
D×1 E
G
F×1
×1
+1 Extra +1 Extra +2 Extra
+1 Extra
ABC
Extra ttings:
D

V
W
X
Y
Z
×4 ×4 ×4
×4 ×2
5/8’’
∅4×16
1-33/64’’
∅7×38
1-9/16’’
∅4×40
Tools Requirements
Images for illustration only
Anti-Tipping Kit

2
1
A
B
• Open the box from the bottom,
take out the foam and legs.
A
×4 ×4
B
C
×4

D
E
3
4
C
A
×4 ×4
B
C
×4
×6 ×1
DE

6
5

7
1
2
3
4
How to take out or reassemble
the drawer ?
1
Follow the appropriate pictogram,
pull inwards the bracket under
the drawer to release the drawer
interlock system.
2
Lift up the drawer and take it out
carefully.
3
Put the drawer at the appropriate
position, make sure the hole under
the drawer side is properly stuck at
the slide.
4
Push outwards the brackets and
lock the drawer.
How to balance the gap between
the drawer fronts?
• Rotate the regulation screw clockwise
to lower the drawer. Rotate it
anticlockwise to raise the drawer.

Furniture Anti-Tipping Kit
Installation
Children have died from furniture
tipover. To reduce the risk of
furniture tipover:
• ALWAYS install tipover restraint
provided.
• NEVER put a TV on this product.
• NEVER allow children to stand,
climb or hang on drawers, doors,
or shelves.
• NEVER open more than one
drawer at a time.
• Place heaviest items in the lowest
drawers.
This is a permanent label.
Do not remove!
WARNING

V
W
X
Y
Z
×4 ×4 ×4
×4 ×2
5/8’’
∅4×16
1-33/64’’
∅7×38
1-9/16’’
∅4×40
Please make sure the screws in the kit t your wall material.
The hardware we provided is only for masonry or drywall
without available wood stud. If you have any questions,
consult your local hardware store.
Tools Requirements
Anti-Tipping Kit

• Attach two brackets securely to the
back top rail of the furniture using the
short screws provided, through the
smaller hole. Then at the appropriate
height and positioned over wood
stud(s), make two marks with a pencil.
8
9
2.75 ”
2.75 ”
• Drill four 5/16 inch (8mm) diameter
holes through the wall at the height
you marked with pencil.
2x

10
11
2.75 ”
2.75 ”
• Drive the plastic plugs into the holes,
using a harmer if needed.
• Attach two brackets securely to the
wall using the long screws provided.
• Move the furniture into its nal
position.
• Lace the end of the restraint strap
through the larger hole in each
mounting bracket.
• Bring both ends together and slide
the at end through the locking end
and draw it through until all slack is
removed.

Care / Cleaning /
Maintenance:
• A little care attention will extend the life and good
looks of your furniture.
• This furniture item should not be exposed to direct
sunlight, extreme temperature or moistures, as this
can result in irreparable damage.
• In case of water splashes, remove water
immediately and wipe.
• Only use a slightly damp,soft,clean cloth on this
surface if cleaning is needed.
• Never use abrasive and scouring agent or solvents.
• Do not scrub or scratch or chip the nish.
• Limits of warranty: The use of cleaning agents
such as chemicals,scouring powders, or any other
aggressive products might damage the furniture
unit and thus the warranty will be voided.

Limited Warranty:
1Y
1-YEAR WARRANTY
• We guarantee this furniture unit for a period
of 1 year from date of purchase.
• The warranty covers any products failure which
may occur due to manufacturing fault.
• However it excludes any part subject to normal
wear and tear,any damaged or defective parts
that result from installation and assembly, misuse
or neglect.
• The specic legal rights of this warranty many vary
from state to state.
• Some states do not allow any exclusion or
limitation of incidental damages.
• Some states do not allow limitation on how long an
implied warranty lasts.

Customer Service:
For all missing of faulty parts:
Please re-check your packaging to ensure that parts
are missing then contact the store you purchased
the item from.
The store will need the following information:
• Copy of your purchase slip/receipt
• Model number of the unit purchased
• Description/part number of the missing
or faulty part
• Quantity of the parts needed
If you whatever reason can not contact the store,
please contact dadada directly:
www.dadadababy.com
Phone number: [phone]