Daewoo RC-220 User manual

2 3
NAMES OF PARTS AND OPERATION TECHNIQUE
HOSE CONNECTION SUCTION CONTROL
• The suction power control at
the hand grib enables you to
control suction power.
EXTENSION PIPE
• Press the button in the
direction shown by the
arrows and pull (or push)
the pipe.
WIDE SUCTION NOZZLE
• TUse this nozzle for cleaning both
carpeted and uncarpeted floors.
ON/OFF SWITCH
• Press the on/off switch.
CORD REWIND BUTTON
• Rewind the power cord by
pressing the cord rewind
button.
DUST METER
• When the colour of the
dust meter is changed to
RED for long time,
change the dust bag.
STORAGE
• If you want to store the
cleaner, hitch the brush clip
onto the vacuum cleaner.
PRACTICAL PARKING
• If you want to stop vacuum
cleaning for a while, you
can place the brush clip
into the rest.
COMBI CREVICE NOZZLE
• Connecting the hose :
insert the hose firmly into
the hose inlet. (“Click”)
•
Disconnecting the hose: press
the button and pull the hose out
of the vacuum cleaner.
restbrush clip

54
CLEANING THE FILTER PRECAUTIONS FOR SAFE USE
This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be responsible for any damage caused by use or operation of the
cleaner contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended. no
liability can be accepted for any possible damage.
CHANGING THE DUST BAG
• Switch off. • Pull the filter case outwards
from the cleaner.
• Separate the filter from the
filter case and shake the
dust out of the filter.
• Do not vacuum areas which contain moisture
or water and inflammable matter, needles,
pins, razor blades, matches, cigarette-ends,
etc., since they may damage the cleaner or
dust bag or cause a fire.
• When rewinding the power cord, hold the
plug body before pressing the cord rewind
button to prevent whipping.
• Do not pull the power cord beyond the
specified length.
• Make sure a dust bag and a motor protection
filter are always inserted.
• This product provided with a cable which, if
damaged must be replaced by a repair shop
authorized by the manufacturer since special
tools are required.
• Switch off and open the
cover.
• Hold the cover while taking the
filter out of the cleaner.
• Shake the dust out of the
filter.
EXHAUST FILTER
MOTOR PROTECTION
FILTER
• Switch off and open the
cover.
• Hold the cover while separating
the dustbag from the dustbag
holder.
• Insert the new dust bag into
the dust bag holder properly
as shown in picture.
Note: If no dustbag has been
placed into the dustbag holder,
the cover cannot be closed.