Dahua NVR608-32-4KS2 Installation and user guide

Equipment Model Firmware Course Version Date
NVR608-32-4KS2 DH_NVR6XX-
4KS2_Eng_V3.210.0003.0.R.160714 V1.0 2017/11/28
How to setup navigation bar?

Page1
Copyright © 2017 Dahua Technologies Co., Ltd. All rights reserved.
Open main menu, SETTINGS->SYSTEM->general, tick
in the red box to enable navigation bar.
Using navigation bar, users can do some quick
operations.
Preview-- Navigation Bar
How to setup Navigation Bar?
Enable Navigation Bar Navigation Bar Operation

Page2
Copyright © 2017 Dahua Technologies Co., Ltd. All rights reserved.
Preview-- Navigation Bar
How to setup Navigation Bar?
Once navigation bar is enabled, click at the middle bottom of the background to call out the function.
①Main menu, Click to go to the main menu interface.
②Click to select screen 2, you can view an interface shown as figure 2. It is a navigation bar for screen2.
③Click any screen split mode, HDMI2 screen can display corresponding screens.
Note: This function is for 2 HDMI model only. Screen 2 function is null if tour is in process, Please disable tour
function first.
Enable Navigation Bar Navigation Bar Operation

Page3
Copyright © 2017 Dahua Technologies Co., Ltd. All rights reserved.
Preview-- Navigation Bar
How to setup Navigation Bar?
Enable Navigation Bar Navigation Bar Operation
④Click button to enable tour, the icon becomes , you can see the tour is in process.
⑤Click , system goes to the PTZ control interface.
⑥Click , system goes to the color interface.

Page4
Copyright © 2017 Dahua Technologies Co., Ltd. All rights reserved.
Preview-- Navigation Bar
How to setup Navigation Bar?
Enable Navigation Bar Navigation Bar Operation
⑦Click button , system goes to search interface.
⑧Click button , system goes to alarm status interface.
⑨Click button , system goes to the channel information setup
interface

Page5
Copyright © 2017 Dahua Technologies Co., Ltd. All rights reserved.
Preview-- Navigation Bar
How to setup Navigation Bar?
Enable Navigation Bar Navigation Bar Operation
⑩Click , system goes to the remote device interface.
⑪Click , system goes to the network interface. It is to set network IP address, default gateway and etc.
⑫Click , system goes to the HDD manage interface.
⑬Click , system goes to the USB manage interface.