Dahua K Series User manual

Dahua K Series Cube Network Camera Quick Start Guide
V 1.0.0
Dahua Technology CO., LTD

1
1
11
1Packing List
Packing List Packing List
Packing List
Device ×1 QSG ×1
Power Adapter ×1 Screw Package ×1
Installation Position Map ×1

2
2
22
2Product Appearance
Product Appearance Product Appearance
Product Appearance
Figure 2-1 Figure 2-2
Figure 2-3
Please refer to the following sheet for more details about each port.
SN Name
1 Network port
2 Reset/WPS button
3 Digital input/output
4 Power port
5 Built-in speaker

3
Sheet 2-1
Note:
For reset, long press for 8 seconds and then the light off; For WPS, one quick press.
Please refer to the following sheet for more details about status of indicator light.
Indicator light status Device status
Red light normally on Booting
Green light slow flashing Booting completed, await wifi config, enter smart
config status;
Green light quick flashing Wifi smart config in progress, including WPS,
management frame and etc.
Green light normally on Wifi connection succeeded, operate normally.
Red and green lights flash
alternately
Device upgrade
Red light slow flashing Network connection failure or disconnection after
network connection success.
Red light quick flashing Device malfunction, fail to boot up; alarm or SD card
malfunction
Sheet 2-2
6 Micro SD card slot
7 Indicator light
8 Built-in MIC
9 IR LED
10 PIR

3
33
3
Operate by Easy4ip
Operate by Easy4ip Operate by Easy4ip
Operate by Easy4ip
1.
Power on the device with power adapter.
2. Connect your smart
phone to your WiFi network.
download and install the
Easy4ip APP
3. Open Easy4ip APP (take
IOS
4. Tap “register” for first use.
Operate by Easy4ip
Operate by Easy4ip Operate by Easy4ip
Operate by Easy4ip
APP
APPAPP
APP
Power on the device with power adapter.
phone to your WiFi network.
Scan the
“Easy4ip APP”
Easy4ip APP
.
IOS
as an example), tap login to login the APP
, see
Figure 3-1
4
“Easy4ip APP”
QR on the packing box,
, see
Figure 3-1.

5. Tap “+” to add devices.
6. Choose “Wireless”.
Figure 3-2
Figure 3-3
5

6
Figure 3-4
7. Name the camera and scan the QR code on camera.

7
Figure 3-5
8. Input the Wi-Fi password.
Figure 3-6

8
9. Waiting for 60s to finish the Wi-Fi connection.
Figure 3-7
Note: If you want to change the Wi-Fi signal, please reset the camera to factory default and repeat
step 6-9;
Figure 3-8

9
4
44
4Operate
Operate Operate
Operate by DMSS APP
by DMSS APPby DMSS APP
by DMSS APP
Step 1
Power on the camera.
Step 2
Connect iphone to a WiFi signal.
Step 3
Open DMSS (downloaded from APP Store), choose Device Manager.
Figure 4-1
Step 4
Click “+”.