Dali DT8 User manual

CW
WW
Push Button Tunable White DALI DT8 Controller 09.2402K4CG.04756
Click to switch on/off group.
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Press and hold down to turn
up/down brightness of group.
Click to get 100% WW and 0%
CW. Press and hold down to
increase WW and decrease CW
Click to get 100% CW and 0%
WW. Press and hold down to
increase CW and decrease WW
DA DA
DALI INPU T
Output DALI signal
Operation Current 30mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 80x80x26.6mm
Product Data
Power Supply Supply By DALI Bus
Wiring Diagram
DALI signal
Rotary Switch for Assigning
Group (Total 16 Groups)
DA DA
DALI INPUT
DALI signal output
Back side
59.3 mm
80 mm
59.3 mm
80 mm
9mm 17.6mm
DA DA
DALI BUS
DALI DT8
DA
DA
DA
DA
Installation
• DO NOT installed with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
• Push button DALI DT8 CCT controller, color type Tc
• Ultra slim and luxury design
• Material and finishing color can be customized
• With back lighting design, easy to find even in dark night
• DALI bus powered, no extra power supply required
• Each channel DALI bus can install multiple controllers
• Enables to select and control 1 DALI group from total 16
DALI groups
• Easy installation with mounting bracket
• Waterproof grade: IP20
Tunable White Device
DALI DT8
Tunable White Device

1. Do wiring according to connection diagram correctly.
2. Set starting Group number via rotary switch on the back: (0-15 selectable)
• This DALI push button controller enables dimming commands and DT8 commands to be sent to One Group of
devices on the DALI circuit. A rotary switch on the back is used to select the DALI Group you would like to
control and set the starting Group number, and total 16 Groups (0-15) can be selected.
• When the rotary switch arrow position is at 0, the controller controls all devices on DALI circuit through
broadcast.
• When the rotary switch arrow position is at X except 0 (1-15), the controller controls devices in Group X-1.
For example: Rotary switch arrow at 1, the controller controls devices in Group 0. Rotary switch arrow at 15, the
controller controls devices in Group 14.
Please refer to the detailed Group setting table as follows:
Rotary Switch
Position
DALI Group
Selected
0
Broadcast
1
0
2
1
3
2
4
3
5
4
6
5
7
6
8
7
9
8
10
9
11
10
12
11
13
12
14
13
15
14
Operation
Note: please assign the devices on DALI circuit to a DALI group(0-15) with DALI master controller first.