Danfoss DEVIreg 330 User manual

www.DEVI.com
Installation Guide
DEVIreg™ 330 (-10 to +10°C)
Electronic Thermostat
EN

DEVIreg™ 330 (-10 to +10°C)
3Installation Guide
1 Introduction
DEVIreg™ 330 is an electronic thermostat to be installed in
electric cabinets with DIN rail attachment. Used primarily for
controlling a lower temperature range as by frost protection.
The thermostat must be installed via an all-pole disconnection
switch. Either a wire sensor or an external air sensor must be
used to measure and control the desired temperature.
The thermostat has a button to adjust the temperature set-
ting, with a scale from -10° to +10°C. An LED indicator shows
standby periods (green light) and heating periods (red light).
More information on this product can also be found at:
devireg.devi.com
1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
1.1 Technical Specications . . . . . . . . . . . . . . . . . . . . 4
1.2 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 5
2 Mounting Instructions . . . . . . . . . . . . . . . . . . . . . . . . 6
3 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
4 Disposal Instruction . . . . . . . . . . . . . . . . . . . . . . . . . 10
Table of Contents

DEVIreg™ 330 (-10 to +10°C)
Installation Guide4
1.1 Technical Specications
Operation voltage 220-240 V~, 50 Hz
Standby power consumption Max 0,25 W
Relay:
Resistive load
Inductive load
Max 16 A / 3680 W @ 230 V
cos φ= 0,3 max1A
Sensing units NTC 15 kOhm at 25 °C
Sensing values:
0 °C
25 °C
50 °C
42 kOhm
15 kOhm
6 kOhm
Hysteresis ± 0,2 °C
Ambient temperature 10 °C to +50 °C
Lowering in economy periods -5 °C
Temperature range -10 °C to +10 °C
Cable specication max 1x4 mm2or 2x2,5 mm2
Ball pressure temperature 75 °C
Pollution degree 2 (domestic use)
Type 1C
Storage temperature -20 °C to +65 °C
IP class 20

DEVIreg™ 330 (-10 to +10°C)
5Installation Guide
Protection class Class II -
Dimensions 86 x 36 x 58 mm
Weight 83 g
The product complies with the EN/IEC Standard“Automatic
electrical controls for household and similar use”:
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
1.2 Safety Instructions
Make sure the mains supply to the thermostat is turned o
before installation.
Please also note the following:
• The installation of the thermostat must be done by an
authorized and qualied installer according to local
regulations.
• The thermostat must be connected to a power supply
via an all-pole disconnection switch.
• The sensor is to be considered as live voltage. Have this
in mind if the sensor must be extended.
• Always connect the thermostat to continuous power
supply.
• Do not expose the thermostat to moisture, water, dust,
and excessive heat.

DEVIreg™ 330 (-10 to +10°C)
Installation Guide6
2 Mounting Instructions
Please observe the following placement guidelines:
• Install the thermostat in an electric cabinet with DIN
rail attachment or a separate DIN attachment accord-
ing to local regulation on IP classes.
• Do not place the thermostat in a way that it will be
exposed to direct sunlight.
Follow the steps below to mount the thermostat:
1. Click the thermostat on to the DIN rail attachment.
2. Connect the thermostat according to the connection
diagram.
-10°C to +10°C

DEVIreg™ 330 (-10 to +10°C)
7Installation Guide
N
L
PE
The screen of the heating cable must be connected
to the earth conductor of the power supply cable by
using a separate connector.
Note: When you use the wire sensor for oor heating,
always install the sensor in a conduit.
3. Turn on the power supply.

DEVIreg™ 330 (-10 to +10°C)
Installation Guide8
3 Warranty
A 2-year product warranty is valid for:
• thermostats: DEVIreg™ 330 (-10 °С to +10 °C).
Should you, against all expectations, experience a problem with your DEVI product,
you will nd that Danfoss oers DEVIwarranty valid from the date of purchase on
the following conditions: During the warranty period Danfoss shall oer a new com-
parable product or repair the product if the product is found to be faulty by reason
of defective design, materials or workmanship.The repair or replacement.
The decision to either repair or replace will be solely at the discretion of Danfoss.
Danfoss shall not be liable for any consequential or incidental damages including,
but not limited to, damages to property or extra utility expenses. No extension of the
warranty period following repairs undertaken is granted.
The warranty shall be valid only if the WARRANTY CERTIFICATE is completed
correctly and in accordance with the instructions, the fault is submitted to the
installer or the seller without undue delay and proof of purchase is provided. Please
note that the WARRANTY CERTIFICATE must be lled in, stamped and signed by the
authorized installer performing the installation (Installation date must be indicated).
After the installation is performed, store and keep the WARRANTY CERTIFICATE and
purchase documents (invoice, receipt or similar) during the whole warranty period.
DEVIwarranty shall not cover any damage caused by incorrect conditions of use,
incorrect installation or if installation has been carried out by non-authorized electri-
cians. All work will be invoiced in full if Danfoss is required to inspect or repair faults
that have arisen as a result of any of the above. The DEVIwarranty shall not extend to
products which have not been paid in full. Danfoss will, at all times, provide a rapid
and eective response to all complaints and inquiries from our customers.
The warranty explicitly excludes all claims exceeding the above conditions.
For full warranty text visit www.devi.com.
devi.danfoss.com/en/warranty/

DEVIreg™ 330 (-10 to +10°C)
9Installation Guide
WARRANTY CERTIFICATE
The DEVIwarranty is granted to:
Address Stamp
Purchase date
Serial number of the product
Product Art. No.
*Connected output [W]
Installation Date
& Signature
Connection Date
& Signature
*Not mandatory

DEVIreg™ 330 (-10 to +10°C)
Installation Guide10
4 Disposal Instruction

DEVIreg™ 330 (-10 to +10°C)
Produced by Danfoss © 01/202308095476 & AQ087986468554en-020304
Danfoss A/S
Nordborgvej 81
6430 Nordborg, Syddanmark
Denmark

DEVIreg 330 +60<>+160˚
140F1073
220-240V~
50-60Hz~
+60 to +160˚C
16A/3680W@230V~
Product Documentation
DK EL 7224215328
SE EL 8581188
NO EL 5402664
FI SSTL 3531034
Designed in Denmark for Danfoss A/S
5703466209233

5678
330
DEVIreg™ 330 (-10 °С to +10 °C)
140F1070
DK EL 7224215302
SE EL 8581184
NO EL 5402659
FI SSTL 3531030
220-240V~
50-60Hz~
-10 to +10°C
16A/3680W@230V~
5 703466 209219
For UK customer only: Importer:
Danfoss Ltd., 22 Wycombe End, HP9 1NB, GB