Darim PVE400 User manual

PVE400 Quick Start Guide
1
1. Connect the Bullet Camera to the camera connector (4) – the white guide markings on the
PVE interface and camera interface should be lined up. If there are no white alignment
dots, simply rotate until it mates.
2. Attach the Antenna to RP-SMA connector (2).
3. Press and hold the Power button (1) until Green Power On LED (5)is on.
4. The unit will take approximately 60 seconds to fully boot at which point it is ready for
operation. The Green Status LED (6) will indicate that unit is ready.
5. Connect PVE-AUX cable to the AUX connector (3) and RG45 side to the PC or switch.
PVE-AUX cable is “straight” Ethernet cable and must be connected through a
hub/switcher unless your computer has autosensing Ethernet port.

PVE400 Quick Start Guide
2
6. Set your PC network adapter to static IP address on subnet 192.168.1.x. For example
192.168.1.100:
7. By default the wired PVE400 Ethernet port is configured with a static IP address
192.168.1.250. By utilizing the PVE-AUX cable you can access the PVE400 and
configure the network settings, a/v settings and diagnostics using the web management
interface by launching the Internet Browser session to http://192.168.1.250.

PVE400 Quick Start Guide
3
8. After browsing the IP address of the PVE unit, the dialog box requesting the user account
should appear. The factory default account is: User: admin : Password: admin
….then the PVE400 Web Management Interface opens.
Note: you may use any Internet Browser for configuration, but the embedded video
plug-in will work only with the Microsoft Internet Explorer on Windows based OS

PVE400 Quick Start Guide
4
9. Once connected you will see the Web Management Interface screen. Select Wireless page
and setup all settings according to your wireless router. For example:
10. Select the VIDEO tab and you will be asked if you want to install the Active X plug-in.
11. Confirm acceptance and when installed you will be able to view live video from the PVE
unit via the Darim’s Active-X plug-in on the VIDEO tab
12. To turn off – press and hold the power button (1) until green Power LED (5) is off.