Dash ZEFON BIO-PUMP User manual

www.dashequipmenthire.com.au | [email protected]om.au | 1300 092 647 | ABN-12 122 126 126
ZEFON BIO-PUMP INSTRUCTIONS
Please read instrucons before using the BIO-PUMP
Inial Instrucons:
For the most accurate test results, please close doors and windows prior to sampling (preferably
24hours before). Outside air may contain high levels of mould spores, and could aect your
results if direct airow from outside is let in.
Note: It is standard pracce to test the air quality outside to give context of the quality of air
in your locaon, and to have something to compare to when tesng indoor air quality.
ZEFON BIO-PUMP

www.dashequipmenthire.com.au | [email protected]om.au | 1300 092 647 | ABN-12 122 126 126
USING THE BIO PUMP AND CARTRIDGES:
Step 1
Place the BIO-PUMP upright in the
affected area, any height from 1.0m to
1.5m off the ground (e.g. on a table/bench). If
the batteries are low, plug in the AC charger
whilst testing. Alternatively, leave the unit
tocharge for an hour.
Step 2
Take a cartridge from the box and write
a location description (e.g. laundry) on the
label. Make sure to number the cartridge,
for referencing purposes. This step is very
critical.
ZEFON BIO-PUMP

www.dashequipmenthire.com.au | [email protected]om.au | 1300 092 647 | ABN-12 122 126 126
Step 4
Turn on the BIO-PUMP by gently pressing
the “Power” button. Press the quick sample
button a few times until you have selected
the “quick sample 5 minute” option (from
the default position, this would be three
times). Once selected, press the “START
STOP” button. The test will take 5 minutes to
complete.
Step 3
Remove the seal from the top and bottom of the cartridge (save to reseal later) and slot the
bottom side of the cartridge into the circular slot under the BIO-PUMP plus label. Ensure
that you are placing the cartridge the right way up. You can do this, but making sure the air
flow direction arrow is facing downwards, towards the pump.
ZEFON BIO-PUMP

www.dashequipmenthire.com.au | [email protected]om.au | 1300 092 647 | ABN-12 122 126 126
Step 5
Once completed, press the power button. Remove the cartridge and place the seals back
onto either end of the cartridge. Place the cartridge back into the box.
Step 6
Repeat STEPS 1-5 if you need to take more tests. Once all tests are completed, book your lab
test and record the receipt number on the Chain of Custody Form provided. Place the BIO-
PUMP, form and cartridges back into the box. Mail or deliver the box back to the following
address: IECL, 3/33 Miller St, Murarrie QLD 4172.
VIDEO INSTRUCTION LINK
ZEFON BIO-PUMP